Samsung SRS620DW owner manual Connect to the water supply line, Warranty Information

Page 32

INSTALLING THE WATER DISPENSER LINE

For Exterior model

Connect to the water supply line

Connect the water pipe with coupler and tap.

-Close the main water tap.

-Connect coupler “A” to the tap.

-Every join should be protected with sealing tape.

WARRANTY INFORMATION

This water line installation is not covered by the refriger-ator or ice maker manufacturer's warranty.

Follow these instructions carefully to minimise the risk of expensive water damage.

Note:

If the coupler does not fit on the current tap, go

the nearest authorised service dealer and purchase the right couplers fittings.

CAUTION

The water line must be connected

to the cold water pipe.

If it is connected to the hot water pipe, it may cause the purifier to malfunction.

COUPLER “A”

TAP

Select the location where the purifier is to install. (Model with the purifier)

-Cut the water line attached to the purifier to the appropriate place after measuring the distance between the purifier and the cold water tap.

-If you wish to reassemble the water inlet and outlet sides of the purifier during purifier installation, see the reference illustration.

LINE OUTLET

	SIDE OF	90 degree
	PURIFIER	90 degree
	PURIFIER

PURIFIERREFERENCE

WATER

WATER INLET	COUPLER
WATER INLET
SIDE OF PURIFIER

Remove any residual matter inside the purifier. (Model with the purifier)

-Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifier.

-If water does not come out through the line, check whether the tap is open.

-Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed.

OUTLET SIDE

OF PURIFIER

WATER

PURIFIER

WATER LINE

32

Image 32

Contents Side by Side Safety Warnings Other Symbols UsedSafety Warning Setting UP the Refrigerator Major FeaturesModels ManualControl Panel Basic Model Dispenser ModelBasic Model With CoolSelect Zone Dispenser Model With CoolSelect ZonePower Freeze Digital PanelTemperature Control Ice DispenserWater Dispenser Cold WaterWhen exposing to child, set the locking device to the Lock Fix the water supply device tightly into the fixing holeSet the locking device to the Lock Fill the tank up to the full level just over 4.2 litresWater Tank / Supply Device BottlesSize RecommendedShelves and Bins Food Storage Guide Tempered Glass ShelfDoor Bin Plastics DrawerChilled Food Storage in Refrigerator Select button Optional Soft FreezeChill Cool600 g Quick Cool buttonThaw button Removing the Freezer Accessories Cleaning the Accessories Changing the Interior Light Deodorizer optionalWater Filter Indicator light Using the dispenser without the water filterOrdering replacement filters Water FilterInstallation of the Refrigerator Checking the Dimensions of your Entrance DoorSelecting the Location for the Refrigerator If not, the water supply line can be damagedRemoving the Front LEG Cover Removing the Front Leg Cover OptionalRemoving the Refrigerator Doors Removing the Freezer DoorRemoving the Refrigerator Door Reattaching the Refrigerator Doors Reattaching the Freezer DoorReattaching the Refrigerator Door Reattaching the Water Tube Optional Reattaching the Front Leg Cover OptionalPlease level the refrigerator first Doors will be uneven if the refrigerator is not levelIf the door of the freezer is lower than that RefrigeratorChecking the Water Dispenser Line Optional Checking the PartsConnecting to water supply line Connect the water line to the refrigeratorCheck the water supply line Do not overtighten the compression nutInstall the water filter Secure the water lineWarranty Information Connect to the water supply lineConnect the water line to the refrigerator Remove any residual matter inside the water supply line Check the amount of water supplied to the ice trayTroubleshooting Ambient Room Temperature Limits