INSTALLATION OF THE WATER DISPENSER LINE
Secure the water line.
-Using clip ”A”, fix the water line to the wall (the back of refrigerator).
-When the water line is secure, make sure it is not excessively bent, pinched or squashed.
Complete the installation of the water supply line.
-Power on the refrigerator and press the lever on the right of the
dispenser until water runs out through the water line and all air has been emptied.
-At this time, check for any possible leakages at the join point in the water line. After securing the water line, move the refrigerator to the required location.
CLIP A
WATER LINE
Install the water filter.
1)Remove the fixed cap (A) as shown. the fixed cap separates from the Water Filter Compartment by rotating it counterclockwise. Remove the water filter from the box and put a month indicator
stick on the filter as shown.
Keep the cap(A) in a safe place for recapping, when you
NOTE don’t need to use the filter. |
|
2) If the water filter was installed in March, put on the "SEP" sticker. | (A) |
3)Remove the Red protective cap from the filter, then position and insert the filter as shown.
4)Slowly turn the water filter clockwise 90º to align
the indication mark on the cover, locking the filter in
position. Do not overtighten.
COVER FILTER
SEPARATION
OF RED CAP
ALIGN THE INDICATION MARK
WITH LOCK POSITION.
STICKER
(MONTH INDICATION)
Please check that the indication line aligns with the lock position.
NOTE
34