INSTALLATION OF THE WATER DISPENSER LINE
NOTE
Install the water filter.
The water filter is located in the extra space behind the vegetable bin.
1) Remove the fixed cap (A) as shown. the fixed cap separates from the Water Filter Compartment by rotating it as shown. Remove the water filter from the box and put a month indicator stick on the filter as shown.
Keep the cap(A) in a safe place for recapping, when you
NOTE don’t need to use the filter.(A)
2)If the water filter was installed in March, put on the "SEP" sticker.
3)Remove the Red protective cap from the filter, then position and insert the filter as shown.
4)Slowly turn the water filter as shown below to align the indication mark on the cover, locking the filter in position. Do not overtighten.
COVER FILTER
SEPARATION
OF RED CAP
ALIGN THE INDICATION MARK
WITH LOCK POSITION.
STICKER (MONTH INDICATION)
• Please check that the indication line aligns with the lock position.
NOTE
Remove any residual matter inside the water supply line after installing filter.
1) Turn on the main water supply &
| supply line. |
|
2) | Run water through the dispenser until the water runs clear | ICE |
| (6~7 minutes). This will clean the water supply system and |
|
| clear air from the lines. |
|
3) Additional flushing may be required in some households. |
| |
4) | Open the refrigerator door and check if water leaks around |
|
| the water filter. |
|
| • A |
NOTE | spurt from the dispenser. |
WATER
26