before using icemaker
Remove
-Hold the handle as shown in figure1.
-Slightly pull up the bottom part.
-Take out the ice bucket slowly.
Install
-Assemble it in the reverse order of disassembly.
-Push the bucket in firmly until you hear a clicking sound.
-When the bucket does not fit into its place, turn the gear handle on its back by 90 degrees and reinstall it again as shown in figure 2.
Before calling service
-Any sounds you hear when the ice maker dumps ice into the bucket are part of normal operation.
-Not dispensing ice for long periods may cause ice clumps in the ice bucket. Remove the remaining ice and empty the bucket.
-When ice does not come out, check the ice stuck in the chute and remove it.
- When ICE OFF blinks on the display panel, reinsert the bucket and/or
make sure it’s installed properly.
CAUTION - When the door is open, the Ice and water dispenser do not work.
-If you close the door hard, it may cause water spilling over the ice maker.
-To prevent dropping the ice bucket, use both hands when removing it.
-To prevent injury, be sure to clean up any ice or water that may have dropped on the floor.
-Do not let the children hang on the ice dispenser or on the bucket. They may get hurt.
-Be sure not to put your hand or any object into the ice chute.
It may cause personal injury or damage mechanical parts.
Figure1
90。
Figure2
Ice Chute
28_ Operating