Thank you very much for buying this SHARP product. Before using your SHARP refrigerator, please read this operation manual to ensure that you gain the maximum benefit from it.
Household use only
WARNING
■ This refrigerator contains flammable refrigerant (R600a: |
isobutane) and insulation blowing gas (cyclopentane). |
Observe the following rules to prevent ignition and explosion. |
• The refrigeration system behind and inside the refrigerator |
contains refrigerant. Do not allow any sharp objects to |
come into contact with the refrigeration system. |
• Do not use mechanical devices or other means to |
accelerate the defrosting process. (This refrigerator has |
adopted automatic defrosting system.) |
• Do not use electric appliances inside the refrigerator. |
• Use only the specified parts for the refrigerator |
compartment light. |
• Do not block the openings on the circumference of the |
refrigerator. |
• Do not use flammable sprays, such as spray paint near |
the refrigerator. It may cause explosion or fire. |
INSTALLATION
WARNING
■Do not install the refrigerator in a damp or wet location as this may cause damage to the insulation and create a leak . Condensation may also build on the outer cabinet and cause rust .
1 Keep adequate ventilation space around the refrigerator.
• The figure shows the minimum required space for installing the refrigerator. The amount of space around the refrigerator affects the amount of power consumption.
• Insufficient spacing will decrease cooling efficiency and increase energy consumption.This may reduce the life of the unit and void warranty.
• If the refrigeration system should get punctured, do not |
touch the wall outlet and do not use open flames. Open |
the window and air out the room. Then ask a service |
agent approved by SHARP for servicing. |
• This refrigerator should be disposed appropriately. |
Take the refrigerator to a recycling plant for flammable |
refrigerant and insulation blowing gases. |
■ Do not store highly volatile and flammable materials such |
as ether, petrol, propane gas, aerosol cans, adhesive |
60mm or more
90 mm or more
1525 mm
60mm or more
1400 mm
Free standing type
agents and pure alcohol etc. |
These materials are liable to explode. |
■ Dust deposited on the power plug may cause fire. Wipe it |
off carefully. |
■ Do not attempt to change or modify this refrigerator. This |
may result in fire, electric shock or injury. |
■ Ensure that the refrigerator presents no danger to children |
while being stored for disposal. (e.g. remove the magnetic |
door seals to prevent child entrapment.) |
CAUTION
■Attention about Power supply:
•Do not use an extension cord or adapter plug.
•Make sure that the power cord has not been damaged during installation or moving. If the power plug or cord is loose, do not insert the power plug. There is a risk of electric shock or fire.
•Disconnect from the mains electricity supply by removing the mains plug from the electricity supply socket. Do not remove by pulling the mains lead. This may cause electric shock or fire.
•Should the flexible supply cord be damaged, it must be replaced by a service agent approved by SHARP as a special cord is required.
■Do not touch the compressor unit or its peripheral parts, as they become extremely hot during operation and the metal edges may cause injury.
■Do not touch foods or metal containers in the freezer compartment with your wet hands. This may cause frostbite.
■Do not place bottled and canned drinks in the freezer as they may crack or explode when frozen.
■In case of gas leak, ventilate the area by opening a window, etc. Do not touch the refrigerator or the power outlet.
■Do not place objects containing liquid or unsteady objects on top of refrigerator.
■This refrigerator is not intended for use by persons
(including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the refrigerator by a person responsible for their safety. Young children should be supervised to ensure that they do not play with the refrigerator.
2 Use the two front adjustable feet, to ensure that the refrigerator is positioned firmly and flat on the floor.
3 Remove the 2 screws of the cabinet lower part, and then set the foot cover (supplied inside the refrigerator compartment) with removed 2 screws.
| Foot cover |
| Screw |
Adjustable foot | (2 screws) |
|
4 Connect the power plug to a 230/240 volt. 10 amp. power point.
NOTE
•Position your refrigerator so that the plug is accessible.
•Keep your refrigerator out of direct sunlight.
•Do not place next to heat generating appliance.
•Do not place directly on the ground. Provide suitable stand.
•If the mains power is switched on when the door is open, the door alarm will sound. Close the door to stop the alarm.
When transporting
•The casters allow the refrigerator to move back and forth.
•Carry the refrigerator by holding the handles located on the rear and the bottom.
rear 
bottom
Casters (4 pcs .)
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water. If soapy water is used, wipe it off thoroughly with water.
3