FM Radio
| Manual programming | English |
| 1 Tune to your desired station (see Tuning to radio | |
| stations). |
|
| 2 Press briefly PROG on the remote control to |
|
| activate programming. |
|
| 3 Press PRESET +/- ( 3 / 4 on the remote |
|
| control ) to allocate a number from 1 to 30 to |
|
| this station. |
|
9 | 4 Press and hold PROG on the remote control |
|
to confirm. |
| |
|
| |
| ➜ The preset number and the frequency of the |
|
| preset station are shown. |
|
Tuning to radio stations
1Press SOURCE (or TUNER on the remote control ) repeatedly until the desired waveband (FM) is displayed.
5Repeat the above four steps to store other stations.
●You can override a preset station by storing another frequency in its place.
2Press briefly SCAN.
➜ The radio automatically tunes to a station with sufficient reception. “Searching.... “ is dispalyed during automactic tuning.
3Repeat step 2 if necessary until you find the desired station.
●To tune to a weak station, press 4 / ¢ briefly and repeatedly until you have found optimal reception.
Tuning to preset radio stations
●Press PRESET +/- ( 3 / 4 on the remote control ) until the desired preset station is displayed.
Programming radio stations
You can store up to a total of 30 radio stations in the memory.
Automatic programming
Autostore automatically starts programming radio stations from preset 1. Any previous presets e.g. manually programmed will be erased.
●Press and hold SCAN for more than two seconds to activate programming.
➜“FM Scanning...” is displayed during searching and storing.
➜All available stations are programmed.
17