STA CK ING in Stru Ction S


The holding cabi net can be stacked wit h an
iden tica l hold ing cabinet or a matchin g rotisserie
oven in either the top or bottom position .
Onl y screws, lock washer s, and hex nut are			a
requ ired to fasten units toget her when stacking
roti sse rie on top of a matchin g holdin g cabinet			or a
hol din g cabinet on top of a holdi ng cab inet.
Addi tional stacking	hardw are is requir ed for all
other comb inations	(SEE PREVIOUS PAGE ).		If the
All fast ening holes have been prepunched.
roti sse rie oven is positioned at the bottom of a
stac ked conf iguration, make cert ain the oven is on a
non -combustible surface.		The stacking combinat ion
also requires the minimum		clea rance of 6" (152mm) at
the back and both sides.

IN STA LLA TION

Remove the two side acce ss pane ls of both uni ts.

Carefully lift and place the upper unit into posi tion aligning on bott om unit.

Secure units tog ether by inserti ng a hex head screw, a fla t washer, and a lock washe r in each hol e of the top unit and screwing them into the inser ts provided on the top of the lower uni t. Securely tighten all fou r screws.

Replace the side panels on both units.

AR-7HOVER AR-7HHOLDING CABINET STACKING ASSEMBLY (5009711)

DETAIL A

ITEM	PART	PART DESCRIPTION	QTY
NO.	NO.	PART DESCRIPTION	QTY
NO.	NO.
1	NU-2437	NUT, 1/4-20 HEX S/S	4

2	SC-27385	SCREW, 1/4-20 X 3/4" LG HEX HEAD	4

3	WS-22094	WASHER, 1/4", FLAT, 5/8 OD 18-8 SS	8

4	WS-2294	WASHER 1/4" SPLIT	4

AR- 7H Hot Hol di ng Ro tis ser ie Companion Operat ion & Care Manual • 7