General Information
E n g l i s h
Congratulations on your purchase, and welcome to Philips! To fully benefit from the suppor t that Philips offers, register your product at www.philips.com/welcome.
This system complies with the FCC rules, Part 15 and with 21 CFR 1040. 10. Operation is subject to the following two conditions:
–This device may not cause harmful interference, and
–this device must accept any interference received, including interference that may cause undesired operation.
Environmental Information
All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).
Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
Never dispose of your product with other household waste. Please inform yourself about the local rules on the separate collection of electrical and electronic products and batteries.The correct disposal of these products helps prevent potentially negative consequences on the environment and human health.
Your product contains batteries, which cannot be disposed of with normal household waste. Please inform yourself about the local rules on separate collection of batteries.The correct disposal of batteries helps prevent potentially negative consequences on the environment and human health.
Please visit www.recycle.philips.com for additional information on a recycling center in your area.
Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate.
Supplied accessories
–2 speaker boxes
–remote control (with battery)
–AM loop antenna
–FM wire antenna
–stand
–screw and plug assembly
Safety Information
●Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer.
●Where the MAINS plug or an appliance coupler is used as the disconnet device, the disconnect device shall remain readily operable.
●Place the system on a flat, hard and stable surface.
●Place the system in a location with adequate ventilation to prevent internal heat
●The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers,
●Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight.
●No naked flame sources, such as lighted candles, should be placed on the apparatus.
●No objects filled with liquids, such as vases, shall be placed on the apparatus.
●If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the system. Should this occur, the CD player would not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.
●The mechanical parts of the set contain self- lubricating bearings and must not be oiled or lubricated.
●When the system is switched to Standby mode, it is still consuming some power. To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.
8