Electrical Requirements

Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply.

Rating label is on the left hand side of fridge inner liner.

We recommend that this appliance be connected to the mains supply via a suitable switched and fused socket. The appliance must be positioned so that the plug is accessible.

Should the mains lead of the appliance become damaged or should it need replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a BEKO Authorised Service Agent.

WARNING! THIS APPLIANCE MUST BE EARTHED

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared cord could cause a shock hazard if inserted into a socket elsewhere in the house.

The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be replaced an ASTA approved BS 1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.

IMPORTANT! FITTING A DIFFERENT PLUG

TRANSPORTATION INSTRUCTIONS

1.The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation.

2.If during the course of transport the appliance has to be transported horizontally, it must only be laid on its right hand side when standing in the front of the appliance. After bringing it to upright position,it must not be operated for at least 4 hours to allow the system to settle.

3.Failure to comply with the above instructions could result in damage occuring to the appliance. The manufacturer will not be held responsible if these instructions are disregarded.

4.The appliance must be protected against rain, moisture and other atmospheric influences.

5.When positioning your appliance take care not to damage your flooring, pipes, wall coverings etc. Do not move the appliance by pulling by the door or handle.

6.Empty any water in the drain tray before moving. See section ‘Defrosting’ and ‘Care & cleaning’ for further information.

7.Make sure that the defrost water pipe at the back of the product is fixed to the plastic evaporating pan on the top of the compressor, to avoid defrost water spillage on the floor.

IMPORTANT : Care must be taken while cleaning / carrying the appliance to avoid touching the bottom of the condenser metal wires at the back of the appliance as you might injure your fingers and hands.

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

(See diagram).

1.Connect the green-yellow or green (Earth) wire to the terminal in the plug marked 'E' or with

the symbol or coloured green and yellow or green.

2.Connect the blue (Neutral) wire to the terminal in the plug marked 'N' or coloured black.

GREEN &

6mm.

YELLOW

32mm.

GREEN

BROWN

6mm.

22mm.

RED

BLUE

12mm.

6mm.

BLACK

CORD GRIP

FUSE

FITTED WITH BS 1362 13A FUSE ALWAYS FIT BS 1362 REPLACEMENT CARTRIDGE FUSE

Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance.

"IMPORTANT: Make sure that mains cable is not caught under the appliance during and after carrying / moving the appliance, to avoid the mains cable becoming cut or damaged."

Do not allow children to play with the appliance or tamper with the controls. BEKO plc declines to accept any liability should the instructions not be followed.

IMPORTANT

INSTALLATION INSTRUCTIONS

1. The space in the room where the appliance is installed must not be smaller

than 10 cubic metres.

2. Do not put your fridge freezer in a cold room where the temperature is likely

to go below +5 degrees C (41 degrees F) during night time and/or especially

in winter.

3.Connect the brown (Live) wire to the terminal in the plug marked 'L' or coloured red.

With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or in the main fuse box.

If in doubt contact a qualified electrician.

This fridge freezer has been designed to operate in ambient temperatures

between +5 and +32 degrees C (41 and 90 degrees F) Therefore if the

appliance is installed in an unheated/cold room (eg: conservatory/annex/

shed/garage etc) then the appliance will not operate causing the freezer

compartment to run warmer and as a result the storage time of frozen food

may be reduced.

CDA 645 F specifications

The Beko CDA 645 F is a versatile and stylish refrigerator freezer that combines advanced technology with practicality, making it an excellent choice for modern households. This appliance is designed to meet the demands of busy lifestyles while ensuring your food remains fresh for longer periods.

One of the standout features of the Beko CDA 645 F is its Frost Free technology. This innovation prevents the build-up of frost in the freezer compartment, eliminating the need for manual defrosting. This not only saves time but also ensures that you utilize the full capacity of the freezer without the annoying hassle of ice accumulation.

The fridge section boasts an impressive capacity, providing ample space for your groceries and perishable items. It features adjustable glass shelves that allow for flexible organization, making it easier to store taller items as needed. Additionally, the dedicated fruit and vegetable crisper drawers maintain optimal humidity levels, ensuring your produce stays fresh and retains its nutritional value.

The Beko CDA 645 F is equipped with an efficient cooling system that utilizes a Multi Air Flow feature. This technology ensures that cool air is distributed evenly throughout the fridge, minimizing temperature fluctuations and creating the ideal environment for food storage.

Energy efficiency is another significant aspect of this appliance. The Beko CDA 645 F is rated with a high energy efficiency class, which means it consumes less electricity, helping you reduce your energy bills and lessen your environmental impact.

Furthermore, the appliance comes with a reversible door feature, allowing you to adjust the door swing to suit your kitchen layout and space constraints. This adds to its versatility, making it easier to fit into various kitchen designs.

In terms of aesthetic appeal, the Beko CDA 645 F comes in a sleek, contemporary design with a stylish stainless steel finish that complements any kitchen décor. Its compact dimensions make it suitable for both large and small kitchens, while still offering significant storage capacity.

Overall, the Beko CDA 645 F stands out as a functional and stylish refrigerator freezer that enhances the efficiency of food storage. With its innovative features, energy-saving technologies, and user-friendly design, it’s an ideal addition to any modern home looking to combine convenience with performance.