Water inlet hose connection
Make sure your plumbing is suitable to install your new dishwasher. If in doubt contact a qualified plumber.
The appliance must be connected to the water mains using the new hose set supplied with your new dishwasher. Old hose sets must not be
The water pressure coming from the water mains supply must be a minimum of 0.3 and a maximum of 10 bars.
Connect the straight end to your water mains supply 1 Ensure plastic filter and black rubber seal is in place.
Please turn on the tap and check for leakages after connecting the hose.
We recommend the tap is turned off when the machine is not being used. If you only have one cold water feed (For example for your washing machine) don’t worry, a Y adaptor will provide you with the additional cold water feed you need for your dishwasher. Y adaptor is available from most DIY stores.
�
Drain Hose Connection
Fit the drainage hose of your machine to the drainage pipe without bending.
Secure your hose firmly to the waste pipe to avoid it coming off during the washing process.
The waste pipe must only be connected into the foul drains and not surface water drainage system.
The hose should be placed between 50 cm and 110 cm from the floor level and must not be extended otherwise the machine may not empty the waste water.
��������� |
|
| |
� |
|
| |
| ���������� | ��� | |
| ��� | ||
|
| ||
�� | ���� | �� �� �� | |
| ��������� | �� | |
�� | �� | ||
| |||
������� | �� | ||
|
| ||
|
| �� | |
|
| �� | |
|
| �� | |
|
| � |
9
GB