Beko LXD 6155 S manual Transportation Instructions, Installation Instructions

Page 8

3Installation

Transportation Instructions

1.The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation.

2.If during the course of transport the appliance has to be transported horizontally, the product must only be laid on its right hand side (when facing the door front) and it must not be operated for at least 4 hours to allow the system to settle after the appliance is brought back to upright position.

3.Failure to comply with the instructions could result in damage occurring

to the appliance. The manufacturer will not be held responsible if these instructions are disregarded.

4.The appliance must be protected against rain, moisture and other atmospheric influences.

5.When positioning your appliance take care not to damage your flooring, pipes, wall coverings etc. Do not move the appliance by pulling by the door or handle.

6.Empty any water in the drain tray and Water Dispenser tank before moving. See section ‘Defrosting’ and ‘Care & cleaning’ for further information.

7.Make sure that the defrost water pipe at the back of the product is fixed to the plastic evaporating pan on the top of the compressor, to avoid defrost water spillage on the floor.

Important Care must be taken when carrying the appliance to avoid touching the bottom of the condenser metal support/pipework at the back of the appliance as you might injure your fingers and hands or damage your

product.8

Important :

Make sure that mains cable is not caught under the appliance during and after carrying/moving the appliance, to avoid the mains cable becoming cut or damaged.

Do not attempt to sit or stand on top of your appliance. You could injure yourself and damage the appliance.

BEKO declines to accept any liability should the instructions not be followed.

Installation Instructions

1.Fit the two plastic wall spacers supplied with the appliance onto the condenser at the back of the appliance by rotating 1/4 turn.

2.Locate the appliance on a smooth surface.

3.To ensure it is standing upright adjust the two front feet by turning clockwise or anti-clockwise, until it is in firm contact with the floor. Correct adjustment of feet avoids excessive vibration and noise.

EN

Image 8
Contents LXD 6155 S Tall Larder FridgeThis manual Symbols and their descriptionsPlease read this manual first Installation Using your refrigeratorMaintenance Cleaning18 Do’s and Don’ts Your refrigeratorYour refrigerator FanDo not damage the refrigerant circuit Electrical requirements FusePackage information Energy saving tipsCompliance with rohs directive Transportation Instructions InstallationInstallation Instructions Changing the illumination lamp 180 Reversing The Doors Page Before operating StartingUsing the water dispenser Water DispenserCleaning the water tank Water trayUsing your refrigerator Using interior compartmentsStopping your product Thermostat controlDefrosting of the appliance Cooling Placing the foodFood storage Maintenance and cleaning Problem Solvıng Do’s and Don’tsHOW to Obtain Service Important notes What is covered?What is not covered? AB/0003 7474