Beko COOL54FDW, COOL54FDS manual Transportation Instructions, Installation Instructions

Page 8

3Installation

TRANSPORTATION

INSTRUCTIONS

1.The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation.

2.If during the course of transport the appliance has to be transported horizontally, it must only be laid on its right hand side when standing in the front of the appliance. After bringing it to upright position,it must not be operated for at least 4 hours to allow the system to settle.

3.Failure to comply with the above instructions could result in damage occuring to the appliance. The manufacturer will not be held responsible if these instructions are disregarded.

4.The appliance must be protected against rain, moisture and other atmospheric influences.

5.When positioning your appliance take care not to damage your flooring, pipes, wall coverings etc. Do not move the appliance by pulling by the door or handle.

6.Empty any water in the drain tray before moving. See section

‘Defrosting’ and ‘Care & cleaning’ for further information.

7.Make sure that the defrost water pipe at the back of the product is fixed to the plastic evaporating pan on the top of the compressor, to avoid defrost water spillage on the floor.

IMPORTANT : Care must be taken while cleaning / carrying the appliance to avoid touching the bottom of the condenser metal wires at the back of the appliance as you might injure your fingers and hands.

Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance.

“IMPORTANT: Make sure that mains cable is not caught under the appliance during and after carrying

/moving the appliance, to avoid the mains cable becoming cut or damaged.”

“IMPORTANT: This appliance is not designed for stacking with any other appliance.When positioning your appliance, take care not to damage your flooring, pipes,wall coverings etc.

Do not allow children to play with the appliance or tamper with the controls. BEKO declines to accept any liability should the instructions not be followed.

IMPORTANT

INSTALLATION

INSTRUCTIONS

1.The space in the room where the appliance is installed must not be smaller than 10 cubic metres.

2.This appliance has been designed to operate in ambient temperatures up to 32 degrees C (90 degrees F) and is equipped with ‘Freezer Guard’ which ensures that at the advised setting [4 - four on the control] the frozen food in the freezer will not defrost even if the ambient temperature falls as low as

-15 °C. So you may then install your

7

EN

Image 8
Contents COOL54FDW COOL54FDS Frost Free Combi Fridge / FreezerThis manual Symbols and their descriptionsPlease read this manual first Your refrigerator Your refrigerator Page Electrical Requirements IMPORTANT! Fitting a Different PlugEnergy Saving Tips Transportation Instructions InstallationInstallation Instructions Page Replacing the Interior Light Bulb Reversing the Doors Page Reversing the doors Before operating Final CheckUsing your refrigerator Temperature Control and AdjustmentSuggested Arrangement of Food in the FRIDGE/FREEZER Making ICE Cubes Storing Frozen FoodFreezing Fresh Food Defrosting Using the water dispenser Water DispenserCleaning the water tank Water tray Maintenance and cleaning Dos and Donts Problem Solving Guarantee Details What is covered?What is not covered? Important notesRepublic of Ireland How To Obtain ServiceModel No Serial No Retailer Part no 57 1887