3D Connexion 555-540-702 manual Switchhook, Ringing Tones

Page 5

The Switchhook

The switchhook is the button held down by the handset when it rests in the cradle on your telephone. Some System 25 features require that you use the switchhook to signal the system.

When you are instructed to press the switchhook, press the button down as far as it will go for approximately 1/2 second and then release it. If the switchhook is released too soon, the signal will not work. If you hold the switchhook down for too long your call will be disconnected.

If you want to hang up and place another call right away, be sure to hold down the switchhook for more than two seconds.

NOTE: If you have a RECALL or FLASH button on your telephone, you can press it instead of the switchhook.

The RECALL or FLASH buttons cannot be used to disconnect a call.

Ringing Tones

System 25 signals you with three distinctive rings. The rings and their descriptions are listed below.

INSIDE CALL IIIIIIIIIIIIIIIIIIII (one long ring)

Your call is from a person inside your company.

OUTSIDE CALL IIIII IIIII (two short rings)

Your call is from the attendant or someone outside your company.

PRIORITY RING IIIII IIIII IIIIIIIIII (two short rings and one long ring) You are being alerted that your request for Callback can now be completed; or a call is being set up remotely for your phone via a data feature known as Third-Party Call Setup.

2

Image 5
Contents AT&T System To Order Copies of this Document Refer to Document Number Contents Introduction FeaturesRinging Tones SwitchhookHandset Tones Additional Information Data Dial Code DDCPersonal Dial Code PDC Account Code Entry Outgoing Calls Account Code EntryAccount Code Entry Incoming Calls Billing Calls to Your Extension Call AccountabilityAnswering Ending the Existing Call Call WaitingAnswering Holding the Existing Call Callback Canceling CallbackRequesting Callback Completing CallbackDropping the Second Person Setting Up Conference CallsConference Calls Returning to the Group Direct Group Calling DGCLeaving the Group Signing FollowingSigning Out Signing Out All ExtensionsForwarding Calls Canceling ForwardingForwarding HoId Placing Another Call Using HoldHold Leaving Messages Leave Word CallingTurning Off Message Lights Message WaitingTurning On Message Lights Answering Night Service Calls Night ServicePaging Using the Paging SystemPicking Up Parked Calls Using ParkPark Picking Up Calls in Your Pickup Group PickupPicking Up Calls Placing Outside Calls Placing CallsPlacing Inside Calls Special Characters Programming Speed Dialing CodesUsing # as a Character Programming or Removing Personal Speed Dialing Codes Placing Calls Speed DialingTransferring Calls TransferGlossary Fpdc PDC Switchhook Quick Reference Card Quick Reference Card Single-Line Telephone