3D Connexion 555-540-702 manual Account Code Entry Incoming Calls

Page 9

Account Code Entry (Continued)

Account Code Entry - Incoming Calls

Your call will be disconnected when you follow this procedure. Therefore, do not attempt it until you have finished your conversation.

1After you have completed your conversation, and before you hang up, press the switchhook.

2Listen for confirmation tone and dial tone.

3Dial ❑* ❑0 .

4 Dial the account code.

NOTE: If you make a mistake while entering the account code, dial ❑* ❑0 again and then the account code.

5 Listen for confirmation tone, then hang up.

6

Image 9

Contents AT&T System To Order Copies of this Document Refer to Document Number Contents Introduction FeaturesRinging Tones SwitchhookHandset Tones Data Dial Code DDC Personal Dial Code PDCAdditional Information Account Code Entry Outgoing Calls Account Code EntryAccount Code Entry Incoming Calls Billing Calls to Your Extension Call AccountabilityCall Waiting Answering Holding the Existing CallAnswering Ending the Existing Call Callback Canceling CallbackRequesting Callback Completing CallbackSetting Up Conference Calls Conference CallsDropping the Second Person Direct Group Calling DGC Leaving the GroupReturning to the Group Signing FollowingSigning Out Signing Out All ExtensionsCanceling Forwarding ForwardingForwarding Calls Using Hold HoldHoId Placing Another Call Leaving Messages Leave Word CallingMessage Waiting Turning On Message LightsTurning Off Message Lights Answering Night Service Calls Night ServicePaging Using the Paging SystemUsing Park ParkPicking Up Parked Calls Pickup Picking Up CallsPicking Up Calls in Your Pickup Group Placing Calls Placing Inside CallsPlacing Outside Calls Special Characters Programming Speed Dialing CodesUsing # as a Character Programming or Removing Personal Speed Dialing Codes Placing Calls Speed DialingTransferring Calls TransferGlossary Fpdc PDC Switchhook Quick Reference Card Quick Reference Card Single-Line Telephone