E.AIR GUIDE REMOVAL (Figure 12)
(1) Separate cavity and base plate.
(2) Unfasten the screws which hold the air guide in the base plate.
(3) Unfasten the air guide from hook.
F.POWER BOARD AND INVERTER MODULE AND SUCTION GUIDE (Figure 12)
(1)Separate cavity and base plate.
(2)Remove air guide.
(3)Unfasten the screws.
(4)Lift up the power board, inverter module and suction guide.
Figure 12 |
G.SENSOR DUCT REMOVAL (Figure 13)
(1) Remove out case.
(2) Unfasten the sensor duct screw.
(3) Disconnect sensor lead wire.
(4) Pull the sensor duct out.
Figure 13 |