LG Electronics 3828W5U0492 installation instructions Install the Mounting Plate

STEP 5: INSTALL THE MOUNTING PLATE

The Oven Must Be Connected To At Least One

Wall Stud.

1.Draw a vertical line on the wall at the center of the 30 wide space. Use the mounting plate as the template for the rear wall. Place the mounting plate on the wall, making sure that the tabs are against the bottom of the cabinet. Line up the notch and center line on the mounting plate to the center line on the wall.

2.While holding the mounting plate with one hand, draw circles on the wall at holes A, B, C and D. Four holes must be used for mounting. If the holes are not used, the installation will not be secure. Installer must use these holes for proper installation. Use toggle bolts through these holes unless one of them lines up with a stud. Use a wood screw for studs.

NOTE: Draw a fifth circle inside area E, through one of the bottom holes to match the location of a stud. For wall- vented: The oven requires a rear wall cutout opening for the rear wall duct and the exhaust adapter must be attached to the mounting plate. See the next page on how to prepare the rear wall cutout opening and the exhaust adapter/mounting plate for wall-vented.

3. Drill holes on the circles. If there is a stud, drill a 3/16 hole

Minimum 66" From the Floor

Mounting

Plate

A

CCenter Line

3/16 Hole on Studs 5/8 Hole on Dry wall Only

For Wall-

Vented Only

Draw Lines on Studs

Draw

Center Line

B

D

E

for lag screws. If there is no stud, drill a 5/8 hole for toggle

bolts. Make sure to use at least 1 lag screw in a stud, and

4 toggle bolts in the drywall or the plaster.

4. Attach the plate to the wall. To use spring toggle head

bolts: Remove the toggle wings from the bolts. Insert the

bolts into the mounting plate and replace the spring toggle

head to 3/4 past the bolt ends. Insert the spring toggle

head into the holes in the wall to mount the plate. You may

pull forward on the plate to help in tightening the toggle

bolts. Tighten all bolts.

	Space More Than Wall Thickness
	Toggle Wings
Mounting
Plate	Toggle Bolt
		Bolt
		End
	Wall

Figure 29

	Support Tab					Support Tab
		(1 piece mounting plate)
				3/16 Hole on Studs
			5/8 Hole on Dry wall Only
Minimum 66"
From the Floor
						For Wall-
					Vented Only

	Draw Lines
	on Studs
	Draw
	Center Line	B
A
	Mounting
	Plate
C Center Line		D
	E
Support Tab	Support Tab

(3 pieces mounting plate)

Figure 28

– 14 –