LG Electronics LFC22760 Crisper Cover with Lattice on Inner, Surface on some models, Dairy BIN

Page 22

CRISPER COVER WITH LATTICE ON INNER

SURFACE (on some models)

To remove the crisper cover:

1.Remove both crisper drawers,

2.While holding the crisper cover support (2), pull the cover up and out(1 ).

_WARNING: Be careful when handing glass cover since glass is not attached to cover.

To remove the lattice on inner surface:

DESIGN-A-DOOR

The door bins are removable for easy cleaning and adjusting.

1.To remove the bin, simply lift the bin up and pull straight out,

2.To replace the bin, slide it in above the desired support button and push down until it stops.

[] WARNING: Somebody can be hurt if door bins are not firmly assembled,

NOTE: DO NOT adjust a bin that is loaded with food,

[] CAUTION: DO NOT allow children to play with baskets, Sharp corners on baskets could cause injury,

1.Remove crisper cover(as illustrated above).

2.Hold the glass cover and overtum crisper cover.

3.For each lattice hold lattice and pull sides of the cover outward to remove lattice,

DAIRY BIN

1.To remove the dairy bin, simply lift it and pull straight out,

2.To replace the dairy bin, slide it in above the desired location and push down until it stops,

To replace lattice on inner surface:

1.For each lattice insert middle tab in 1 (closed to glass cover)and pull sides of the cover to insert lattice,

EGG BOX

Store Egg Box on interior shelf, not on door shelf,

[]CAUTION: Do not use the egg box as an ice storage bin in the freezer compartment, The egg box can easily easily break if it freezes,

22

Image 22
Contents Rador Elador About the Custom English Version French Version Warranty Safety InstructionsWater Line Assistance Numbers LG ElectronicsCustomer Product Parts LaborPartes Mano de Obra Periodo de Garantia del refrigerador/CongeladorEstados Unidos de Am6rica Para obtener informacionPage Before YOU Throw Away Your OLD Refrigerator Or Freezer To Connect ElectricityRecommended Grounding Method USE of Extension CordsUsethissectionto becomemorefamiliarwiththepartsandfeatures Unpacking Your Refrigerator InstallationWhen Moving Your Refrigerator NextHowto Remove Door Handles Howto Replace Door HandlesRight Door Replacing Refrigerator Door Right Door Left DoorRemoving Refrigerator Door FigureACorrect HOW to Remove and Install the Pullout Drawer Removing Pulout DrawerInstalling Pullout Drawer Leveling and Door Alignment LevelingEnsuring Proper AIR Circulation Door AlarmSetting the Controls MULTI-FLOWSetting the Controls Adjusting Control SettingsStoring Fresh Food Food Storage GuideStoring Frozen Food MilkRefrigerator Shelves To remove a sliding shelf from its metal frameCrisper Humidity Control Chef Fresh / Snack PANObtibin Crispers On some modelsDESIGN-A-DOOR Crisper Cover with Lattice on InnerSurface on some models Dairy BINTilting Door on some models How to useICE BIN on some models Durabase on some modelsFilter on some models Water DispenserPull out the cartridge Outside General Cleaning TipsLight Bulb Replacement Condenser CoilsWhen YOU GO on Vacation Power InterruptionsWhen YOU Move Normal Sounds YOU MAY Hear When YOU should Setthe Icemaker Power Switch to O OFFOperation Instructions Preparing for VacationWhat YOU will Need Power drillBefore YOU Begin = Choose ThevalvelocationConnect the Tubing to the Valve Fasten the Shutoff Valve= Tighten the Pipe Clamp Flush OUT the TubingPlug in the Refrigerator = Connect the Tubing to the RefrigeratorTU RN TH E Water on AT the Shutoff Valve Start the IcemakerVibration or Rattling Noise Understanding Sounds YOU MAY HearRefrigerator does not Operate Lights do not WorkFrost or ICE Crystals on Frozen Food Compressor Motor Seems to RUN TOO MuchDoors will not Close Completely Check ThenRefrigerator Seems to Make TOO Much Noise ICE has OFF-TASTE or OdorThere is Water in the Defrost Drain PAN Cubes Produced by Icemaker are TOO SmallIs Interior Moisture Buildup Temperature is TOO Warm or ThereAutomatic Icemaker does not Work Heck if