INSIAllAIION
HANDLE REMOVAL (CONT.)
HANDLE REINSTALLATION
Mounting
Fasteners
\
J
Place the handle on the door by aligning handle footprints to fit mounting fasteners and tighten the set screws with a 2.5 mm (3/32") Allen wrench.
NOTE: If the handle mounting fasteners need
to be tightened or removed use a 1/4" Allen wrench
DOOR AND DRAWER REMOVAL
DOOR REMOVAL
&WARNING
Electric Shock Hazard
•Disconnect electrical supply to the refrigerator before installing. Failure to do so could result in death or serious injury.
•Do not put hands or feet or metal sticks into the air vents, base grille, or bottom of the refrigerator. You may be injured or receive an electrical shock.
•Be careful when you work with the hinge, base grille, and stopper. You may be injured.
Before you begin, remove food and bins from the doors.
If your entrance door is too narrow for the refrigerator to pass through, remove the refrigerator door and move the refrigerator sideways through the doorway.
[
Place the handle on the door by aligning handle footprints to fit mounting fasteners and tighten the set screws on the bottom of the handle with a 3.1 mm (1/8") Allen wrench.
NOTE: If the handle mounting fasteners need
to be tightened or removed use a 1/4" Allen wrench.
To remove the left refrigerator door:
Pull the water tube out of the fitting while pressing the release ring on the fitting.
NOTE : When you pull out the tube, first you have to push the collet by opposite direction of arrow in the upper picture and pull the tube out by direction of arrow.
10