INSIAllAIION
FLOORING
•To minimize noise and vibration, the refrigerator MUST be installed on a solidly constructed floor.
•To avoid vibration, the unit must be level. If required, adjust the leveling legs to compensate for unevenness of the floor. The front should be slightly higher than the rear to aid in door closing. The leveling legs can be turned easily by pushing against the top of the refrigerator to take the weight off the feet. Turn the leveling legs clockwise to raise the unit or counterclockwise to lower it.
•Carpeting and soft tile surfaces are not recommended.
•Never install the refrigerator on a platform or weakly supported structure.
NOTE: When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it.
Do not wiggle or walk the refrigerator when trying to move it; floor damage could occur.
NOTE: It is recommend that the doors be removed when it is necessary to move the refrigerator through a narrow opening.
HANDLE REMOVAL
To move the refrigerator through a house door, it may
be necessary to remove the refrigerator door handles.
NOTE: Handle appearance may vary from illustrations on this page.
Mounting
Fasteners
&CAUTION
•Use special care when removing handles to prevent scratching the doors.
•The handle could be damaged if you hit it with a hammer while removing or attaching.
•When you assemble or disassemble a handle, you must push or pull with reasonable force.
f
Set Screw
Allen Wrench
Loosen the set screws with a 2.5 mm (3/32") Allen wrench and remove the handle.
NOTE: If the handle mounting fasteners need to be tightened or removed, use a 1/4" Allen wrench.
Loosen the set screws located on the lower side of the handle with a 3.1 mm (1/8") Allen wrench and remove the handle.
NOTE: If the handle mounting fasteners need to be tightened or removed, use a 1/4" Allen wrench.
9