USING YOUR REFRIGERATOR
WATER FILTER
It is recommended that you replace the filter when the water filter indicator light turns on or your water dispenser or ice maker performance decreases noticeably.
2. Replace with a new cartridge.
Take the new cartridge out of its packaging and remove protective cover from the
With cartridge knob in the vertical position, push the new filter cartridge into the cover until it stops.
push | push |
Filter | Fresh |
|
After changing the water filter cartridge, reset the water filter status display and indicator light by pressing and holding the button for 3 seconds.
1. Remove the old cartridge.
If you are replacing the cartridge, first remove the old one. Open the cartridge cover by pressing in on the tab
(1) at the front and pulling down (2).
If you can’t turn the filter from side to side, it isn’t fully inserted. Push it in firmly and use its handle to twist the cartridge clockwise about 1/4 turn. You will hear a snap when it clicks into place.
1
push Filter
2
push
1 Fresh
Rotate the knob of the cartridge counter clockwise until it clicks forward.
Pull out the cartridge.
3.Flushing the Water System After Replacing Filter Dispense water through the water dispenser for 3 minutes to purge the system.
NOTE: To purchase replacement water filter cartridges, visit your local appliance dealer or part distributor. You can also visit our website : www.lgappliances.com or call
NOTE: There will be water in the cartridge. Some spilling may occur.
24