LG Electronics LRFD25850, LRFD21855 Refrigerator Installation, Unpacking Your Refrigerator, Next

Page 8

REFRIGERATOR INSTALLATION

WARNING

Excessive Weight Hazard

Use two or more people to move and install refrigerator.

Failure to do so can result in back or other injury.

UNPACKING YOUR REFRIGERATOR

Remove tape and any temporary labels from your refrigerator before using. Do not remove any warning- type labels, the model and serial number label, or the TechSheet that is attached to back wall of the refrigerator.

To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.

Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. For more information, see the Important Safety Instructions section.

Refrigerator shelves are installed in the shipping position.

Please reinstall shelves according to your individual storage needs.

WARNING

When Moving Your Refrigerator:

Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it. Do not wiggle or walk the refrigerator when trying to move it, as floor damage could occur.

INSTALLATION

1.To avoid vibration, the unit must be level. If required, adjust the leveling screws to compensate for unevenness of the floor. The front should be slightly higher than the rear to aid in door closing. Leveling screws can be turned easily by tipping the cabinet

slightly. Turn the leveling screws clockwise ( ) to

raise the unit, counterclockwise ( ) to lower it.

2.Install this appliance in an area where the temperature is between 55°F (13°C) and 110°F (43°C.) If the temperature around the appliance is too low or high, cooling ability may be adversely affected.

3.Allow the clearance of at least 2 inch from the ceiling and 1 inch from the side walls for better cooling efficiency, ease of installation, proper air circulation and electrical connections.

wCAUTION: Avoid placing the unit near heat sources, direct sunlight or moisture.

NEXT

1.Clean your refrigerator thoroughly and wipe off all dust accumulated during shipping.

2.Install accessories such as ice cube bin, drawers, shelves, etc., in their proper places. They are packed together to prevent possible damage during shipment.

3.Let your refrigerator run for at least 2 or 3 hours before putting food in it. Check the flow of cold air in the freezer compartment to ensure proper cooling. Your refrigerator is now ready for use.

wWARNING

•Be careful when you work with hinge, base grille, stopper etc. You may be injured.

•Do not put hands or foot or metal sticks into air vents, base grille or bottom of refrigerator. You may be injured or receive an electrical shock.

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from refrigerator.

Failure to do so can result in death, explosion or fire.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Congélateur Inférieur Réfrigérateur Table of Contents LG ELECTRONICS, INC LG Refrigerator Limited Warranty USA Authorized Service Center. Phones are answeredPlease call 1-800-243-0000 and choose Appropriate option to locate your nearest LGLimited Warranty Canada LG Refrigerator Do not modify or extend the Power Cord length Important Safety Instructions Read all instructions before using this appliance CFC Disposal Grounding RequirementsTo Connect Electricity Recommended Grounding MethodParts and Features Refrigerator Installation InstallationUnpacking Your Refrigerator NextHOW to Remove Door Handles Removing Refrigerator HandleScrews Mounted On back On doorHOW to Replace Door Handles Replacing Refrigerator Door HandleReplacing Freezer Drawer Handle Screws Mounted On door Keyhole slots On back HandleRight Door Removing and Replacing Refrigerator DoorsRemoving Refrigerator Door Left Door Replacing Refrigerator Door Right Door Correct IncorrectRemoving Pullout Drawer HOW to Remove and Install the Pullout DrawerInstalling Pullout Drawer Leveling and Door Alignment LevelingTo remove the base cover To replace base coverUsing Your Refrigerator Setting the ControlsEnsuring Proper AIR Circulation MULTI-FLOWAdjusting Control Settings Food Storage GuideStoring Frozen Food Water DispenserAdjusting Shelves Refrigerator ShelvesWine Holder Sliding Out ShelvesRemoving Crisper Optibin CrispersCrisper Humidity Control Crisper Cover with Lattice on Inner Surface To remove crisper door flapTo remove the glass To remove the lattice on inner surfaceGlide N Serve Modular Door BINCold Temp Control Colder Controls To remove Glide N ServeHow to use Dairy BINEGG BOX Tilting DoorDurabase Durabase DividerPull OUT Drawer To remove basketRemove the old cartridge Water FilterReplace with a new cartridge Care and Cleaning Power Interruptions When YOU GO on VacationWhen YOU Move To change freezer lightWhen YOU should SET the Icemaker Power Switch to O OFF About the Automatic IcemakerOperation Instructions Normal Sounds YOU MAY HearConnecting the Water Line Fasten the Shutoff Valve Connect the Tubing to the ValveTighten the Pipe Clamp Flush OUT the TubingConnect the Tubing to the Refrigerator Start the Icemaker Turn the Water on AT the Shutoff ValvePlug in the Refrigerator Troubleshooting Guide Refer to the Setting the Controls sectionUnderstanding Sounds YOU MAY Hear Check if… Then…See the Adjusting Control Settings section Care and Cleaning section on pagesCompletely below See Leveling and Door Alignment onMay Hear section on Production. See the Setting the ControlsRefer to the Understanding Sounds You See Doors will not close completely on
Top Page Image Contents