LG Electronics LRFD25850, LRFD21855 manual Connect the Tubing to the Refrigerator

Page 30

CONNECTING THE WATER LINE

9.CONNECT THE TUBING TO THE REFRIGERATOR

Removing and Replacing Valve Cover

NOTE:

•Before making the connection to the refrigerator, be sure the refrigerator power cord is not plugged into the wall outlet.

1.Loosen screw on top of plastic cover.

2.Lift off the cover by slightly pushing up.

4.Insert the tube into the valve and fasten with wrench as shown in the figure below.

Tubing

wCAUTION: Check to see if water dripping occurs at water line connections.

5.Bend the tube upwards and fasten it into the clamp provided to hold it in position. Replace the cover and tighten the cover screw.

Tubing

Clamp

Tubing

3.Place a compression nut and a ferrule(sleeve) onto the end of tubing.

Compression Nut

Ferrule (sleeve)

Image 30

Contents Congélateur Inférieur Réfrigérateur Table of Contents Please call 1-800-243-0000 and choose LG ELECTRONICS, INC LG Refrigerator Limited Warranty USAAuthorized Service Center. Phones are answered Appropriate option to locate your nearest LGLimited Warranty Canada LG Refrigerator Important Safety Instructions Read all instructions before using this applianceDo not modify or extend the Power Cord length To Connect Electricity CFC DisposalGrounding Requirements Recommended Grounding MethodParts and Features Unpacking Your Refrigerator Refrigerator InstallationInstallation NextScrews HOW to Remove Door HandlesRemoving Refrigerator Handle Mounted On back On doorReplacing Freezer Drawer Handle HOW to Replace Door HandlesReplacing Refrigerator Door Handle Screws Mounted On door Keyhole slots On back HandleRemoving and Replacing Refrigerator Doors Removing Refrigerator Door Left DoorRight Door Replacing Refrigerator Door Right Door Correct IncorrectHOW to Remove and Install the Pullout Drawer Installing Pullout DrawerRemoving Pullout Drawer To remove the base cover Leveling and Door AlignmentLeveling To replace base coverEnsuring Proper AIR Circulation Using Your RefrigeratorSetting the Controls MULTI-FLOWAdjusting Control Settings Food Storage GuideStoring Frozen Food Water DispenserWine Holder Adjusting ShelvesRefrigerator Shelves Sliding Out ShelvesOptibin Crispers Crisper Humidity ControlRemoving Crisper To remove the glass Crisper Cover with Lattice on Inner SurfaceTo remove crisper door flap To remove the lattice on inner surfaceCold Temp Control Colder Controls Glide N ServeModular Door BIN To remove Glide N ServeEGG BOX How to useDairy BIN Tilting DoorPull OUT Drawer DurabaseDurabase Divider To remove basketWater Filter Replace with a new cartridgeRemove the old cartridge Care and Cleaning When YOU Move Power InterruptionsWhen YOU GO on Vacation To change freezer light Operation Instructions When YOU should SET the Icemaker Power Switch to O OFF About the Automatic Icemaker Normal Sounds YOU MAY HearConnecting the Water Line Tighten the Pipe Clamp Fasten the Shutoff ValveConnect the Tubing to the Valve Flush OUT the TubingConnect the Tubing to the Refrigerator Turn the Water on AT the Shutoff Valve Plug in the RefrigeratorStart the Icemaker Understanding Sounds YOU MAY Hear Troubleshooting GuideRefer to the Setting the Controls section Check if… Then…Completely below See the Adjusting Control Settings sectionCare and Cleaning section on pages See Leveling and Door Alignment onProduction. See the Setting the Controls Refer to the Understanding Sounds YouMay Hear section on See Doors will not close completely on