Liebherr HC1060 Changing the door hinges, To detach the soft stop mecha- nism, Reversing the door

Changing the door hinges

u Examine the unit and packaging for shipping damage. Contact the carrier immediately if you suspect there is any damage.

u Note the type (model, number), index, appliance/serial number, date of purchase and where purchased on the spaces provided in see Appliance Information.

u Remove anything attached to the rear or side walls of appliance that would prevent proper installation or im- pede proper ventilation.

If the appliance is set up in humid areas, condensation may build on the outside of the appliance.

u Always ensure proper ventilation.

3 Changing the door hinges

Make sure you have the following tools on hand: q Hex wrench 13

q Cordless screwdriver Torx 15, 20, 25, 30

Push the appliance 2/3 of the way into the recess. Disconnect the power plug.

Open the doors.

3.1To detach the soft stop mecha- nism*

CAUTION

Risk of injury if soft stop contracts! u Detach with care.

Fig. 1

uUnscrew retainer Fig. 1 (1).

uUnscrew ball stud Fig. 1 (3) together with the soft stop mechanism Fig. 1 (2) from the door and set to one side.

3.2 Reversing the door

Fig. 2

u Lift off covers Fig. 2 (5,6,7,8) using a slot screwdriver. u Just loosen top and bottom screws Fig. 2 (9) on the body

of the appliance.

u Push doors outwards and unhook.

u Swap screws Fig. 2 (9) to the opposite side and screw them in a little.

CAUTION

Risk of injury if hinges fold! u Leave hinges open.

u Undo screws Fig. 2 (10) and change over the hinges di- agonally.

The screws Fig. 2 (10) are self-tapping: use a cordless screwdriver.

u Tighten the hinges.

u Close off the now unused fastening holes with the plugs Fig. 2 (11) supplied.

u Hang doors on the pre-fitted screws Fig. 2 (9) and tighten screws.

3.3Re-attaching the soft stop mecha- nism*

Fig. 3

u Screw on retainer Fig. 3 (1).

3