WINE COOLER ZONE
Zone selection | Labels |
| |
W The wine cooler zone is divided into two compart- | The appliance is supplied with |
| |
ments whose temperatures can be adjusted inde- | a label for each shelf. Use |
| |
pendently of one another, according to your needs. | these to label the type of wine |
| |
To select a temperature zone, press button 9. The | stored on each shelf. Use a |
| |
corresponding compartment will be shown in the display. | soft pencil on the labels so | B | |
Setting the light to Dim mode | that you can erase it again | ||
when necessary. |
| ||
On glass door models, you can set the light to Dim mode us- | Additional labels can be obtained from your dealer. |
| |
ing the "Light" button bl. You can select the brightness of the |
| ||
W Insert the labels from above as illustrated in fi gure B. |
| ||
interior light when the door of the wine cooler zone is closed. |
| ||
|
| ||
W If the button is dark, the light becomes dimmer and dimmer |
|
| |
once the door has been closed and fi nally goes out. | Folding the wooden grid shelf |
| |
W To activate the Dim mode, press the "Light" button bl | Your appliance is equipped with a foldable wooden grid shelf | ||
briefl y until it lights up. | |||
for each wine cooler compartment. |
| ||
By pressing buttons bl and 8, you can determine the |
| ||
Use this option to safely store wine |
| ||
brightness. To increase the brightness use bl and "Up" and |
| ||
bottles which have been opened. |
| ||
to decrease the brightness use bl and "Down". Both wine |
| ||
To fold the wooden grid shelf, press |
| ||
cooler compartments are activated at the same time. |
| ||
the catch under the cover strip to |
| ||
|
| ||
| the side. The wooden grid shelf folds |
| |
| down. |
|
!WARNING
DO NOT load more than 26.5 lb (12 kg) of products per shelf.
!CAUTION
Do not adjust a shelf with products on it. Failure to follow these instructions may re- sult in minor or moderate injury or damage.
Removing the wooden grid shelves
The foldable wooden grid shelf runs on
lift it upwards from the
that the shelf does not remain attached to the catch at the back. To insert, slide the shelf under the catch at the back and then press the shelf onto the rails until you hear it click
into place.
The lower wooden grid shelf can be removed as follows: Pull the shelf out towards you at an angle
and at the same time, lift it up. To insert, slide in the shelf above the stop
fi tted on the intervening shelves until it touches the rear wall and push down.
Replacing the activated charcoal filter
The way in which wines continue to mature depends on the ambient conditions. The quality of the air is therefore decisive for preserving the wine. To guarantee an optimal throughput of air, an activated charcoal fi lter is fi tted in each wine cooler compartment. Please refer to appliance overview for position, fi gure A.
We recommend that you replace the fi lter once a year. Filters can be obtained from your dealer.
Changing the filter:
WTake the fi lter by the handle. Turn it 90° to the left or right and remove.
WInserting the fi lter: Insert with the han- dle in a vertical position. Turn it 90° to the left or right until it clicks into place.
1
2
1
A delight in freshness
8 | WF1051 / WFI 1051 |