Liebherr WFI1051, WF1051 manual Installation Guidelines, Area Requirements, Electrical Requirement

Page 6

INSTALLATION GUIDELINES

Area Requirements

Verify the following:

Floors can support refrigerator’s weight plus approximately 1200 pounds (544 kg) of food weight.

Finished kitchen floor height has to be level. Kitchen cabinet, that the appliance is installed in, must be shimmed to the floor level, if the floor heights are not equal.

Remove anything attached to the rear or side walls of appliance that would prevent proper installation or impede proper ventillation.

Cutout dimensions are accurate.

Electrical outlet is in correct location.

Do not install this refrigerator-freezer next to any other refrigerator or freezer except another Liebherr model. Liebherr models are designed to allow side-by-side installation. They are equipped with

a heating system to eliminate condensation when refrigerators or freezers are installed side-by-side. Installing this refrigerator-freezer next to any other refrigerator or freezer can cause condensation or cause damage to the Liebherr refrigerator-freezer.

Electrical Requirement

If codes require a separate grounding circuit to be used, have a qualified electrician install the circuit.

!WARNING

ELECTRICAL SHOCK HAZARD!

Do not ground to a gas pipe. Check with a qualified electrician if you are not sure the appliance is properly grounded. Do not have a fuse in the neutral or grounding circuit.

Failure to follow these instructions could result in death or serious injury.

!WARNING

ELECTRICAL SHOCK HAZARD!

Electrically ground refrigerator.

Do not use an extension cord.

Failure to follow these instructions could result in fire, death or serious injury.

!WARNING

ELECTROCUTION HAZARD!

Electrical Grounding Required. This appliance is equipped with a three-prong (grounding) polarized plug for your protection against possible shock hazards.

DO NOT remove the round grounding prong from the plug.

DO NOT use a two-prong grounding adapter.

DO NOT use an extension cord to connect power to the unit.

Failure to follow these instructions could result in death or serious injury.

Customer’s Responsibility

A 115 Volt, 60 Hz, 15 Amp fused electrical supply is required. We recommend using a dedicated circuit for this appliance to prevent electrical overload. Follow the National Electrical Code and local codes and ordinances when installing the receptacle.

Venting the Appliance

DO NOT restrict the air flow. Air flow must be provided for the appliance to operate. The factory air vents provide 31 square inches (200 cm2) of air flow per appliance. If you are replacing the factory air vents with an overlay, the air flow must be the same or greater than the factory air vents.

A delight in freshness

2

WF1051 / WFI 1051

Image 6
Contents Use and Care Manual Delight in freshness Features Description of appliance and equipmentType/Data plate, fi gure A3 Please Read and Follow These Instructions Table of Contents Electrical Requirement Installation GuidelinesArea Requirements Customer’s ResponsibilityImportant Safety Information Disposal of Old ApplianceSafety Regulations SN-TUnpacking Disposal of CartonExamining Loose Parts Figure Operation and Control Elements Wine Cooler Zone Setting the light to Dim mode Zone selection LabelsReplacing the activated charcoal filter Freezer Compartment Information systemFreezer tray Wine cooler zone Freezer Compartment CleaningCleaning Freezer compartmentIcemaker To Start the IceMakerTo make ice cubes To Clean the IceMaker Figure JLoud running noise TroubleshootingInterior light does not come on Appears in the displayToll Free 1-866-LIEBHERR or Mail Liebherr@adcoservice.com Customer Service FigureLiebherr Service Center Appliance InformationWarranty Liebherr Warranty Plan

WF1051, WFI1051 specifications

The Liebherr WFI1051 and WF1051 are advanced refrigeration and freezing appliances designed to meet the needs of both professional kitchens and residential use. Renowned for their innovative features and robust construction, these appliances are perfect for preserving food quality and ensuring optimal storage conditions.

One of the standout features of the Liebherr WFI1051 and WF1051 is their high energy efficiency. Incorporating advanced cooling technologies, these models utilize a state-of-the-art compressor along with optimized insulation to minimize energy consumption. This not only reduces utility costs but also helps in promoting sustainable practices. Both units are equipped with an Energy Star rating, indicating their compliance with strict efficiency standards.

Temperature management is another critical aspect of the Liebherr WFI1051 and WF1051. The appliances feature precise electronic controls that allow users to easily set and monitor temperatures. With a temperature range that can be adjusted to suit different food preservation needs, these units ensure that perishable items are stored under ideal conditions. Additionally, they come with a powerful cooling system that maintains consistent temperatures, preventing fluctuation that can compromise food safety.

The Liebherr WFI1051 and WF1051 boast a sleek design, characterized by their stainless steel exteriors and ergonomic layouts. This modern aesthetic not only enhances the kitchen’s appearance but also makes cleaning and maintenance easier. The interior of both models is thoughtfully designed, offering ample shelving space that can be easily rearranged to accommodate various food items, from bulk packages to small containers.

Technology plays an essential role in the functionality of these units. Equipped with a user-friendly digital display, the Liebherr WFI1051 and WF1051 allow for straightforward operation, giving users instant access to essential information such as current temperature and diagnostic alerts. Integrated LED lighting illuminates the interior, enhancing visibility without generating excess heat.

Safety features are also a priority in the design of these appliances. Both models include a door alarm that alerts users if the door has been left ajar, thereby preventing temperature loss. Additionally, they are designed with a child lock feature, ensuring that settings are secure from unauthorized adjustments.

In summary, the Liebherr WFI1051 and WF1051 stand out for their combination of energy efficiency, innovative storage solutions, user-friendly technology, and modern design. These appliances are ideal for those seeking dependable, high-performance refrigeration solutions for their kitchen needs. Whether for commercial or domestic use, they provide the reliability and advanced features necessary for optimal food preservation.