Liebherr 7082 308-00 manual Operation and control elements

Operation and control elements

You are advised to clean the appliance before switching it on for the first time (see "Cleaning").

Switch on the appliance approx. 4 hours before loading it with frozen food for the first time.

Setting the temperature

fig. A1

WTurn the temperature control with a coin until the desired temperature is indicated in the display. The slot posi- tions mean:

Setting 1 = highest temperature, lowest cooling setting Setting "max." = lowest temperature, highest cooling setting

WRecommended temperature setting: -18°C.

GB

Connecting to the mains

Power supply (AC) and voltage

at the operating point must comply with the details on the type plate, which is located inside the appliance on the left, fig. A.

WConnect the appliance with a properly earthed fused plug and socket only.

WThe socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible.

WDo not

-connect to stand-alone inverters,

-operate with so-called energy-saving plugs - this can damage the electronic system,

-connect to the supply with other equipment using an

extension cable - risk of overheating.

WWhen removing the mains cable from the back of the ap- pliance, remove the cable holder as well so as to avoid vibration noise.

The wires in the mains lead are coloured in accordance with the following code: green/yellow = earth, blue = neutral, brown = live.

Warning! This appliance must be earthed.

Non-rewireable plugs BS 1363

If this machine or appliance is fitted with a non-rewireable plug, the following information applies: If the socket outlets are not suitable for the plug supplied with this product, it must be cut off and an appropriate plug fitted. The plug cut from the flexible cord should be disposed of and on no ac- count be inserted into a 13 A socket elsewhere in the house (electric shock hazard).

The fuse cover must be re-fitted when changing the fuse, and if the fuse cover is lost the plug must not be used until a suitable replacement is obtained. The colour of the cor- rect replacement cover is that of the coloured insert in the base of the plug, or the colour that is embossed in words on the base of the plug (as applicable to the design of the plug fitted). The correct rating of the replacement fuses that are ASTA approved to BS 1362 should be fitted. Replace- ment fuse covers may be purchased from your local elec- trical suppliers, electricity showroom or approved service agent.

Switching the appliance on and off

fig. A1

WTo switch on: Turn the temperature control 1 with a coin so that the slot is pointing to setting 2.

-The red visual warning light will be on until the freezer has reached a sufficiently low temperature, then it goes out. See "Audible warning signal, red visual warning light" for more information.

-A green light on the temperature display will light up and indicate that the appliance is in normal mode.

WTo switch off: Set the temperature control to "0".

- The temperature display and all buttons will go out.

Temperature setting display

fig. A1/3

- When the temperature display is illuminated, this indi- cates that the appliance is running.

-The five blocks in the display each relate to a different temperature range. They indicate the freezer tempera- ture setting you have selected.

-Within the temperature / setting range, e.g. when the display reads -15 °C to -18 °C, or between two set- tings*, the temperature can be set slightly colder. If required, slowly turn the temperature control 1 further - the light displaying the temperature range, e.g. -18 °C, flashes for a short time. This confirms the higher setting within the small temperature range.

Audible warning signal, red visual warning light

fig. A1

The audible warning signal and the red visual warning light are designed to help you to protect your frozen food and to save energy.

WThe audible warning device is switched off by press- ing the audible warning on/off button 4.

-It switches off automatically as soon as the temperature is low enough.

-It always sounds if the freezer temperature is not low enough (dependent on the temperature setting).

-The red visual warning light will flash simultaneously. This can be caused by:

-warm, fresh food being placed in the freezer,

-too much warm air from the outside entering when re- arranging or removing frozen food. These temperature fluctuations will not affect the quality of the frozen food.

-When the audible warning on/off button is pressed, the visual warning light will stop flashing and will light up continuously. It will only go out once the alarm status stops and the temperature inside the freezer is low enough. The audible warning signal will then switch back to standby automatically.

WIf the SuperFrost button flashes at the same time as one of the lights on the temperature display, this means that your appliance has a fault. Contact your customer service department and tell them that this visual warning is active, so that they can arrange for your appliance to be serviced accurately and quickly.

GN..3 * Depending on model and options 15