Auto off function
The system automatically switches off if there is no audio input and when you do not use it for approximately 30 minutes.
1Press [iPod/AUX] to select AUX mode.
Status indicator: Off
2Press and hold [OK].
On (default) ↔ Off
On: The green status indicator blinks 1 time, followed by the amber status indicator blinking 2 times.
Off: The green status indicator blinks 1 time, followed by the amber status indicator blinking 1 time.
Note:
1 minute before the system switches off, the power indicator blinks.
Maintenance
To clean this system, wipe with a soft, dry cloth
•Never use alcohol, paint thinner or benzine to clean this system.
•Before using chemically treated cloth, read the instructions that came with the cloth carefully.
RQT9648
8
Troubleshooting
Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the solutions indicated do not solve the problem, consult your dealer for instructions.
No power
• Ensure the AC mains lead is connected properly.
No sound
•Increase the volume of the system.
•Examine the volume of the iPod/iPhone or portable audio equipment.
•Make sure that the iPod/iPhone or portable audio equipment is actually playing something.
Sound is distorted
•Lower the volume of the system.
•Make sure that the equalizer function of the iPod/ iPhone or portable audio equipment is switched off.
No operations can be done with the remote control
•Remove the insulation sheet before you use the remote control for the first time.
•Examine that the battery is installed correctly.
•The battery is weak. Replace it with a new one.
Green status indicator blinks
•The system is checking the connected iPod/iPhone. If the battery of iPod/iPhone is depleted, the system will charge the iPod/iPhone before it can connect to the iPod/iPhone.
•Switch off the system and then switch it on again.
iPod/iPhone does not switch on
•Examine the battery of iPod/iPhone to make sure it is not depleted. Charge the iPod/iPhone.
•Switch off the system and then switch it on again.
iPod/iPhone does not respond
•Make sure that the system is in iPod mode.
•The iPod/iPhone is not connected correctly. Remove the iPod/iPhone and connect it again.
iPod/iPhone does not charge
• Examine the connection.
Specifications
Amplifier section
RMS output power stereo mode Front Ch (both ch driven)
20 W per channel (6 Ω), 1 kHz, 10% THD
Total RMS stereo mode power | 40 W | |
Terminal section |
|
|
AUX (rear) |
|
|
Terminal |
| Stereo, 3.5 mm jack |
Speaker section |
|
|
Type | 1 way, 1 speaker system | |
|
| (bass reflex) |
Speaker unit(s) |
|
|
Full range |
| 6.5 cm cone type |
Impedance |
| 6 Ω |
General |
|
|
Power supply | AC 110 to 240 V, 50/60 Hz | |
Power consumption |
| 17 W |
Dimensions (W x H x D) |
|
|
Main set (without stand) | 400 mm x 175 mm x 91 mm | |
Mass |
| 2.7 kg |
Operating temperature range | 0°C to +40°C | |
Operating humidity range |
| 20% to 80% RH |
|
| (no condensation) |
Power consumption in standby mode
0.2 W (approximate)
Note:
•Specifications are subject to change without notice. Mass and dimensions are approximate.
•Total harmonic distortion is measured by the digital spectrum analyzer.
8