Liebherr 7085638-01 Insertion into a row of kitchen units, Disposing of packaging

Putting into operation

4.4 Insertion into a row of kitchen units

Fig. 7

u Lift the stopper Fig. 7 (33) out of the door bearing bush and transfer it.

u Dismantle the door handle Fig. 7 (32), stoppers Fig. 7 (33) and pressure plates* Fig. 7 (34) and transfer to the opposite side.

u When fitting the pressure plates on the opposite side, make sure they snap properly into place.*

4.3.4 Fitting the door

u Place the door from above onto the lower bearing pin Fig. 5 (22).

u Close the door.

u Insert the upper turn hinge Fig. 4 (12) in the door on the new hinge side.

u Screw the upper turn hinge Fig. 4 (12)firmly into place (with 4 Nm)(2x Torx® 25) Fig. 4 (13). Possibly make preliminary holes with a bradawl or use a cordless screwdriver.

u Snap the cover Fig. 4 (10) and cover Fig. 4 (11) into place at the opposite side.

4.3.5 Aligning the door

u Align the door to the appliance housing by way of the two oblong holes in the bottom turn hinge Fig. 5 (25). To do so, unscrew the middle screw.

WARNING

Risk of injury due to the door dropping out!

If the bearing parts are not screwed into place firmly enough, the door may drop out. This may lead to severe injuries. What is more, the door may not close and therefore the appliance may fail to cool properly.

u Screw the turn hinges firmly into place with 4 Nm. u Check all of the screws and retighten if necessary.

(1)	Stack cabinet	(3)	Kitchen cabinet Fig. 8
(2)	Appliance	(4)	Wall

xFor appliances supplied with wall spacers, the measurement increases by 35 mm (see 4.2) .

The appliance can be inserted into a row of kitchen units. To match the appliance Fig. 8 (2) to the height of the row of units, a suitable stack cabinet Fig. 8 (1) can be fitted above the appli- ance.

When installing with kitchen units (max. depth 580 mm), the appliance can be positioned directly next to the kitchen cabinet Fig. 8 (3). The appliance will project by 34 mmx at the sides and 50 mmx in the centre of the appliance in relation to the kitchen cabinet front.

Ventilation requirements:

-At the back of the stack cabinet there has to be a ventilation duct of at least 50 mm depth throughout the width of the stack cabinet.

-The ventilation space under the ceiling has to be at least 300 cm2.*

-the larger the ventilation space, the more energy-saving the appliance is in operation.

If the appliance is installed with the hinges next to a wall Fig. 8 (4), the distance between appliance and wall has to be at least 40 mm. This corresponds to the projection of the handle when the door is open.

4.5 Disposing of packaging

WARNING

Danger of suffocation due to packing material and plastic film! u Do not allow children to play with packing material.

* Depending on model and options 7