Controls and displays
•If refrigerant escapes: eliminate naked flames or sources of ignition from the vicinity. Pull out the power plug. Venti- late the area well. Notify customer service.
-Do not store explosives or sprays using combustible propel- lants such as butane, propane, pentane, etc. in the appli- ance. Respective spray cans can be identified by reference to the contents printed on the can or by a flame symbol. Gases possibly escaping may ignite due to electrical components.
-Keep burning candles, lamps and other items with naked flames away from the appliance so that they do not set the appliance on fire.
-Only store
Danger of tipping and falling:
-Do not misuse the plinth, drawers, doors etc. as a step or for support. This applies particularly to children.
Danger of food poisoning:
-Do not consume food which has been stored too long.
Danger of frostbite, numbness and pain:
-Avoid lasting skin contact with cold surfaces or refrigerated/ frozen food or take protective steps, e.g. wear gloves. Do not consume ice cream, water ice or ice cubes immediately and do not consume them too cold.
Please observe the specific information in the other sections:
| DANGER | identifies a situation involving direct |
|
| danger which, if not obviated, may |
|
| result in death or severe bodily |
|
| injury. |
| WARNING | identifies a dangerous situation |
|
| which, if not obviated, may result in |
|
| death or severe bodily injury. |
| CAUTION | identifies a dangerous situation |
|
| which, if not obviated, may result in |
|
| minor or medium bodily injury. |
| NOTICE | identifies a dangerous situation |
|
| which, if not obviated, may result in |
|
| damage to property. |
|
|
|
| Note | identifies useful information and tips. |
3 Controls and displays
3.1 Operating and control elements
(1) | Up setting button | (7) | Fig. 3 |
On/Off button | |||
(2) | Down setting button | (8) | SuperFrost button |
(3) | Menu symbol | (9) | Alarm button |
(4) | Alarm symbol | (10) Power failure symbol | |
(5) | SuperFrost symbol | (11) | |
(6) | Temperature display | (12) HomeDialog symbol | |
3.2 Temperature display
The following are displayed in normal operation:
-the warmest freezing temperature
The temperature display flashes:
-the temperature setting is being changed
-after
-the temperature has risen several degrees
Dashes flash in the display:
-the freezer temperature is above 0 °C.
The following displays indicate malfunction. Possible causes and corrective action (see Malfunction).
-F0 to F9
-The power failure symbol 
shines.
4 Putting into operation
4.1 Transporting the appliance
CAUTION
Risk of injury and danger of damage as a result of incorrect transport!
u Transport the appliance in a packed condition. u Transport the appliance upright.
u Do not transport the appliance without assistance.
4.2 Installing the appliance
In the event that the appliance is damaged, contact the supplier immediately before connecting to the mains.
The floor at the site must be flat and level.
Do not install the appliance in a location where it is exposed to direct radiation of the sun, next to a cooker, heater and similar. The ideal installation site is a dry, well ventilated room.
Always install the appliance with the back directly against the wall.
Do not install the appliance without assistance.
Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m2 per 8 g of R 600a refrigerant used in the appliance. If the room in which the appli- ance is installed is too small, a flammable
The appliance may be moved only when it is empty.
WARNING
Fire hazard due to dampness!
If live parts or the mains lead become damp this may cause short circuits.
u The appliance is designed for use in enclosed areas. Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions.
WARNING
Fire hazard due to refrigerant!
The refrigerant R 600a is environmentally friendly but flam- mable. Escaping refrigerant may ignite.
u Do not damage the piping of the refrigeration circuit.
4