Liebherr liebherr manual Mounting the anti-tipping device, Water pressure, Installation

Mounting the anti-tipping device

WARNING!

The supplied anti-tipping bracket must be installed in all cases. This prevents the appliance from tipping over when the fully loaded door is opened.

Installation:

1.Mark the centre line of the appliance on the floor. Align the anti-tipping bracket centre to the centre line.

CAUTION!

Ensure that there are no electric cables or water pipes in the wall section to which the anti-tipping bracket is to be secured. These could be damaged during installation.

2.Secure the anti-tipping bracket to the floor using the 3 screws (6 mm x 60 mm) included in the accessory pack.

The distance between the leading edge of the body of the unit and the rear edge of the anti-tipping bracket is 610 mm.

Important!

When securing the anti-tipping bracket to a concrete floor, use suitable plugs!

If the floor slopes down sideways, the anti-tipping bracket must be fitted horizontally. Lay down spacers in the appropriate positions.

Wall

Connection to the water supply

Safety instructions and warnings

• Donotconnecttothewatersupplywhilethecombinedrefrigerator- freezer is connected to the electricity supply.

• The connection to the mains water supply may only be made by trained personnel.

• The water quality must comply with the drinking water directives of the country in which the appliance is used.

• The ice maker is designed exclusively to make ice cubes in quantities required by a household and may only be operated with water suitable for this purpose.

• All repairs and work on the ice maker may only be carried out by customer service personnel or other trained personnel.

• Themanufacturercannotacceptliabilityfordamagecaused by a faulty connection to the mains water supply.

Water pressure

The water pressure must be between 0.15 and 0.6 MPa (1.5 - 6 bar).

Important:

If the water filter is inserted in the appliance, the water pressure must lie between 0.3 and 0.6 MPa (3 - 6 bar).

If the water pressure with the inserted water filter is too low,

this may cause the ice maker to malfunction.

The water supply to the appliance must be through a cold water pipe that can withstand

the operating pressure and complies with the hygiene regulations. For this, use the stainless steel hose supplied (length 3 m).

Installation

1.Place the appliance in front of the instal- lation recess.

2. Applycoverstripsontheside walls of the appliance.

14