Liebherr 211111 7085270 - 00 Installing the appliance, Built-under variants

Putting into operation

Built-under variants:

Fig. 9 for recess height 820 or 870 mm A = Height of recess

B = Height of unit plinth

C = Height of unit door

D = Base height of cut-away unit plinth

Recess	Height of unit	Height of unit	Base height of
height A	plinth B	door C	unit plinth D
820 mm	100 mm	716 mm	100 mm
820 mm	170 mm	646 mm	100 mm
870 mm	150 mm	716 mm	150 mm
870 mm	220 mm	646 mm	150 mm

Note

u Before assembling the door of the unit, make sure that the admissable weight of the unit door is not exceeded.

u Otherwise damage to the hinges and resultant malfunction cannot be ruled out.

Model	Max. weight of unit
	door
UIK	10 kg
UIG	20 kg

2.3.1 Installing the appliance

uDetach the connecting cable from the rear of the appli- ance, removing the cable holder at the same time because otherwise there will be vibratory noise!

uLay the connecting cable with the help of a string in such a way that the appliance can be easily connected after fitting.

Fig. 8	Fig. 10
	u Extend the front height-adjustable feet in preparation,
	depending on recess height.
	Slide in and align the appliance:
	NOTICE
	Risk of harm to flooring susceptible to damage!
	u Place a strip of cardboard under the height-adjustable feet,
	approx. 10 cm x 60 cm, one at either side. Cut the strips out
	of the packaging. For opening heights less than 826 mm,
	use strips of a firm but thin material.
	u After the appliance has been slid in, remove the strips.
	u Slide the appliance into the
	recess and align the front
	edges of the hinges so that
	they are flush with the side
	wall of the unit.
	Fig. 11
	w The distance between the front edge of the side wall of the
	unit to the appliance body is 41.5 mm all the way round.
	(Allow for door stop components, such as knobs and sealing
	lips.)
	For units with door stop components (knobs, sealing
	lips etc.):
	u Allow for the extra distance (depth of the door stop compo-
	nents): Allow the hinges to protrude by the additional
	distance required.

5