OPERATION
Operating and
Control Elements - Figure 5
Figure 5
1.Temperature display
2.Temperature setting buttons
3.Alarm ON/OFF button
4.Interior light ON/OFF button
5.Childproof Lock
6.ON/OFF button
7.Fan switch
8.Fan symbol
Turning the Appliance
ON and OFF - Figure 6
Clean the appliance before turning it on for the first time. See Cleaning. Connect the appliance to the dedicated outlet - the appliance is turned on.
•To turn the appliance off: Keep the ON / OFF button pressed for three seconds so that the tem- perature display goes out.
•To turn the appliance on: Press the ON / OFF button until the display lights up.
Figure 6
Setting the Temperature - Figure 7
To reduce the temperature: Press the “DOWN“ button;
To increase the temperature: Press the “UP“ but- ton.
-While you are entering the temperature, the set temperature will flash on the display.
-You can change the settings in increments of 1°F (1°C) by briefly pressing the button again. The electronic controls will switch over automati- cally about five seconds after the last time you pressed the button. The actual temperature dis- plays.
Figure 7
If F0 or F1 appears in the display, the appliance has a fault. Contact your nearest customer service rep- resentative, indicate the type of appliance, index and Appliance / serial number.
Fan switch - Figure 8
The fan switch can be used to increase the relative humidity in the wine cooler zone.
•To switch on: Press buttons 3and 4 simul- taneously. The fan symbol will be shown in the display.
The fan is permanently in operation = higher humidity.
•To switch off: Press the buttons again so that the fan symbol goes dark.
The fan runs in parallel to the compressor = lower
humidity.
Note:
-The energy consumption will increase when the fan is switched on.
-To save energy, the fan will switch off automati- cally when the door is open.
Figure 8
10