Liebherr 7082 344-01 manual Freezer compartment Cleaning, Freezer tray, Cold-storage, Accumulators

Freezer compartment		Cleaning
Freezer tray*		er with a neutral pH value. Only use food compatible
This is used for gently freezing		cleaning and care agents on the inside of the appliance.
berries, herbs, vegetables and		W Use a commercially available stainless-steel cleaning
other small items and prevents		agent for stainless-steel appliances*.			GB
them from sticking together. Items		- In order to achieve best possible protection, apply a stain-
being frozen will largely retain		less-steel care agent uniformly in grinding direction after
their shape, and it will be easier to		cleaning. Points which are darker at the start and a more in-
remove exactly the right quantity later on.		tensive coloration of the stainless-steel surface are normal.
W Spread the items out loosely on the tray.		- Do not use abrasive sponges or scourers, do not use con-
W Suspend the freezer tray in one of the top drawers. Freeze		centrated cleaning agents and never use cleaning agents
for 10 to 12 hours, then transfer to a freezer bag or contain-		containing sand, chloride or acid or chemical solvents, as
er and put in a drawer.		these would damage the surfaces and could cause corro-
W To defrost, spread the frozen items out loosely.		sion.
		W Do not allow cleaning water to run down the drain gulley
Cold-storage		or to penetrate the ventilation grilles or electrical compo-
		nents. Dry the appliance.
accumulators*		- Remove the protective film from the decorative trims*.
These prevent the temperature in		- Do not damage or remove the type plate on the inside of
the freezer from rising too quickly		the appliance. It is very important for servicing purposes.
in the event of a power failure, thus		W To clean the storage shelves:
preserving the quality of the food.		- lift the shelves, slide forwards and remove.
W To save space, you can freeze and store the cold-storage
		Always insert shelves with the guard bar at the back point-
accumulators in the freezer tray.
		ing upwards, otherwise food may freeze onto the rear wall.
- To ensure maximum storage time in the event of a power
failure, place the frozen cold-storage accumulators in the		- The glass shelves are fitted with stops to
top freezer drawer on top of the food.		prevent them being pulled out acciden-
		tally.		2
Making ice-cubes*		W To clean the BioFresh drawers, pull the	3
		drawers right out, grip at back and lift out		1
W Fill the ice-cube tray with water.		(fig. M1).		L
W Place the ice-cube tray in the appli-
ance and leave it to freeze.		- To re-insert: place the drawers on the
W The ice-cubes can be removed from		extended rails - the rails must align with
the tray by twisting or by holding		the front of the drawer - and slide in
upside down for a short time under		(fig. M2).		M1
running water.		- Simply pull the drawer cover out to-
		wards you. When re-inserting, make sure
		the bearing pins snap into place in the
		grooves.
		The drawer and the cover must be flush		M2
		with one another vertically.
Cleaning		W Clean the drain hole in the rear wall fre-
		quently, fig. N, arrow. If necessary, clean
Notes on defrosting		with a thin object, e.g. a cotton swab
		or similar.		N
The NoFrost system automatically defrosts the appliance.		W The dust should be removed from the
In the BioFresh compartment		refrigeration unit and heat exchanger
		- metal grid at the back of the appliance
The water is evaporated by the heat from the compressor;		- once a year. Dust deposits increase
drops of water on the rear wall are perfectly normal.		energy consumption.
W Simply ensure that the defrost water can flow freely through		W Ensure that none of the wires or other
the drain hole in the rear wall (arrow in fig. A).		components are dislodged, bent or
		damaged.
In the freezer compartment		W Then connect/switch on the appliance
		and start to insert the food to be frozen as
Any moisture arising collects on the evaporator and freezes,		the temperature drops.
and is periodically defrosted and evaporated.		If the appliance is to be left switched off for any length of
The automatic defrosting system keeps the freezer frost-free		time, empty the appliance, disconnect from the mains, clean
and eliminates the time and effort spent on defrosting manu-		as described above and leave the door open so as to avoid
ally.		odours.
Cleaning
W Before cleaning, always switch off the appli-
ance. Disconnect from the mains or unscrew or
remove the fuse.
W Clean the outer walls, inside and equipment by hand with
lukewarm water and a little detergent. Because of the risk
of injury and damage to the appliance, steam clean-ing
equipment should not be used.
W We recommend using a soft cloth and an all-purpose clean-
BN/SBN/es...6	* Depending on model and options			19