DEFROSTING/CLEANING
Defrosting - Figure 13
The BioFresh compartment |
|
defrosts automatically. The water |
|
that forms on the rear wall |
|
drains into a reservoir at the |
|
back of the appliance and |
|
evaporates automatically |
|
through the compressor heat. | Figure 13 |
Ensure the defrost water can flow freely through the drain hole in the rear wall (Figure 13).
Cleaning - Figure 14
!WARNING
•To prevent possible injury due to an electrical shock, be sure to disconnect the power cord or turn OFF the circuit breaker before replacing the interior light bulb(s) or cleaning the appliance.
•To avoid injury or damage, DO NOT use steam cleaning equipment to clean the appliance.
Clean the appliance by hand with lukewarm water and a little detergent. DO NOT place components in a dishwasher to clean.
DO NOT use abrasive or scouring sponges. DO NOT use concentrated cleaning agents. NEVER use abrasive or acid cleaners or chemical solvents.
Keep your stainless steel looking new by cleaning with a good quality stainless steel cleaner or polish monthly. High quality stainless steel cleaners and conditioners are commercially available.
DO NOT CLEAN WITH STEEL WOOL PADS or ABRASIVE PADS. DO NOT use cleaners that are not for use on stainless steel, such as glass, tile or counter cleaners. These types of cleaners can damage the surface permanently.
Stainless steel that is exposed to chlorine gas and moisture may have some discoloration. This discoloration is normal. If your unit is used in this environment, clean and polish your stainless steel more often.
If the surface discolors or rusting appears, clean it quickly with a
To clean the storage shelves:
Lift the shelves, slide forward and remove.
Always insert shelves with the guard bar at the back pointing upwards, otherwise food may freeze onto the rear wall.
The glass shelves are designed to prevent the shelves from being pulled out accidentally.
To clean the BioFresh drawers:
Pull the drawers out and grip at the back, and lift out.
To reinstall:
•place the drawers on the extended rails, the rails must align with the front of the drawer and slide in.
•pull the drawer cover out towards you. When reinstalling, make sure the bearing pins snap into place in the grooves.
The drawer and the cover must be flush with one another vertically.
Clean the drain hole (Fig. 14) in the rear wall frequently. If necessary, clean with a thin object, like a cotton swab or something similar.
•Ensure no cleaning water penetrates into the electrical components or ventilation grille.
•Dry all parts well with a cloth.
Figure 14
* Depending on model and options
16 | BFI/BF1055 (7082 |