General Remarks
IV. Area Requirements
Verify the following:
•Floors can support refrigerator’s weight plus approxi- mately 1200 pounds (544 kg) of food weight. Not
all Liebherr products are designed for 1200 pounds (544 kg) of food. Some units are smaller and total weights may vary.
•Finished kitchen floor height is level. Refrigerator must be shimmed to the floor level, or levelled, to make sure, air vents are not obstructed.
•Remove anything attached to the rear or side walls that can obstruct refrigerator opening.
•Cutout dimensions are accurate.
•Electrical outlet is in correct location.
Do not install this unit next to any other refrigerator or freezer except another Liebherr model. Liebherr models are designed to allow side by side installation. They are equipped with a heating system to eliminate condensa- tion when units are installed side by side. Installing this unit next to any other refrigerator or freezer can cause condensation or cause damage to the Liebherr unit.
To protect the refrigerator from possible damage, allow the appliance to stand 1/2 to 1 hour in place before turning the electricity on. This allows the refrigerant and system lubrication to reach equilibrium.
Blocking For Safety
The
V. Safety Regulations
The appliance complies with UL250 and
The appliance is set to operate within specific ambient temperature limits according to its climate rating. These temperature limits should not be exceeded. The cor- rect climate rating for your appliance is indicated on the model plate.
This is explained as follows:
Climate | Set for Ambient Temperatures of |
Rating |
|
|
|
SN | 50°F to 90°F (10°C to 32°C) |
N | 61°F to 90°F (16°C to 32°C) |
ST | 61°F to 100°F (16°C to 38°C) |
T | 61°F to 109°F (16°C to 43°C) |
50°F to 100°F (10°C to 38°C) | |
50°F to 109°F (10°C to 43°C) | |
|
|
- The refrigerant circuit has been tested for leaks.