Rangemaster U110121 - 01A manual Installing your fridge-freezer

Installing your fridge-freezer

1.	Fit the appliance towards the left-hand side of the
	housing unit, leaving a gap of approximately 5 mm.
2.	This fridge-freezer has front adjustable feet, which can
	be used to level the appliance.
	Using a suitable spanner, adjust the feet. Turn the
	spanner clockwise to raise the feet and counter-
	clockwise to lower the feet (Fig.4-13).
	The appliance should be flush with the underside of the
	housing unit.
3.	Fix the appliance to the top shelf of the housing unit.
	This will help to keep the appliance vertically parallel
	with the décor doors.
4.	Adjust the appliance so that it measures 40 mm
	between the appliance front edge and the front edge
	of the housing unit (Fig.4-14). Fix the appliance in
	position.
5.	Trim the side gasket to the appropriate size and insert it
	into the 5 mm gap on the left-hand side of the appliance
	(Fig.4-15).
6.	Remove the screw caps and the screw (Fig.4-16).

Fig.4-13

-0116 - BIFF - Adjusting the

Fixing brackets Fig.4-14

5 mm gap

40 mm

7.	Fix the bracket supplied with the fixing kit into position
	(Fig.4-17).
8.	Fit the slider guides on the edge of the appliance doors
	(there are 2 slider guides per door). Insert the sliders
	into the slider guides.
9.	Mark the distance from the front edge of the furniture
	door to the edge of the slider. This measurement should
	be approximately 20 mm (Fig.4-18).
10.	Fix the sliders into position; the screws must be fully
	tightened.
11.	Check that both furniture doors open and close

Fig.4-15

Side gasket

Fig.4-16

properly without fouling on the cabinet.

IMPORTANT: Make sure that the doors of the appliance and the door seals are shutting properly against the body of the fridge freezer.

To check, close the door seal onto a thin strip of paper (about 25–50 mm wide) and confirm that the seal grips the paper.

Fig.4-17

Gasket

Retaining

bracket

Fig.4-18

Cabinet door

20 mm

Appliance	Slider
door	Slider guide

13