Activating the Dual Elements, Preheat Function

Note: The ‘+’ keys have a repeat function: holding the key pressed down will increase the power setting by one level every 0.3 seconds.

To reduce the power to a cooking zone select the required zone, as indicated by the red dot in the display. Press the ‘–‘ key to reduce the power required.

Note: The ‘–’ key has a repeat function: holding the key pressed down will reduce the power setting by one level every 0.3 seconds.

To shutdown a cooking zone:

Make sure the required cooking zone has been selected, as indicated by the red dot in the display. Reduce the power to

0.After three seconds have elapsed the element will switch oﬀ automatically.

Rapid shutdown:

To switch oﬀ a selected zone press the ‘+’ and ‘–‘ keys simultaneously: this will immediately switch oﬀ that zone.

Note: After a zone has been switched oﬀ an ‘H ’ may appear in the display. This is a residual heat indicator that shows that the cooking zone temperature is above 60°C and may still cause burns. Once the temperature has dropped to below 60°C the ‘H ’ will go out.

To switch oﬀ all cooking zones:

All of the cooking zones can be immediately switched oﬀ by pressing the On/Oﬀ key. Any ‘hot ‘ zones that were in use will show an ‘H ’ in the display (Fig.2-8).

Activating the Dual Elements

Select the required cooking zone: a red ‘dot’ will show on the relevant display. Set the required power level and then press the Dual Zone key (Fig.2-9). The dual element selected will activate and an indicator will illuminate in the zone display.

The Dual Zone key will toggle the zones on and oﬀ.

Preheat Function

This function allows for rapid heating up of the element to bring the selected cooking zone up to temperature. Once the zone is at the required cooking temperature the power level will reduce automatically to the preset level.

To activate the preheat function:

Select the required cooking zone: a red ‘dot’ will show on the relevant display.

Press the ‘–’ key to bring the element up to full power.

Press the ‘+’ key to activate the auto function (as indicated by the ‘A’).

Use the ‘–‘ key to set the preset power level (Fig.2-10).

When the ‘A’ alternates with the selected power setting the preheat function is in operation.

Fig.2-8

Art No. 315-

��Fig.2-9

��

Art No. 315-0011 RC77 dual element

Fig.2-10

Rangemaster RC77 manual Activating the Dual Elements, Preheat Function