Hitachi 309521J important safety instructions Cart-mounted

Cart-mounted

1.Secure metering valve assembly (6) to cart/stand with screws (913), washer (914), and nuts (915). FIG. 1, page 8.

2.Connect fluid lines (provided by installer) between pumps and metering valves.

3.Cut air line tubing (included) to length needed to connect between metering valves (601) and sole- noid outlets. FIG. 3, page 10, and FIG. 6.

Bottom of Valve A

Bottom of Valve B

DOSING VALVES	AIR MOTOR
	PILOT VALVES
OPEN	Pilot Valve A side
	Pilot Valve B side
CLOSE

Top of Valve B

Top of Valve A

FIG. 6: Control Box - bottom

Remote Fluid Manifold

To install remote fluid manifold, order part no. 15A898. All other parts referred to in the following procedure are parts you remove from the stan- dard manifold and reuse or parts the installer must supply.

1.Remove metering valves (601) and shutoff valves (606, 611) from fluid manifold (607). FIG. 7.

2.Install metering valves (601) and shutoff valves (606, 611) onto fluid metering manifold 15A898. FIG. 8.

• Maximum length of tubing is 36” (914 mm). Locate fluid manifold as close as possible.

Assemble

601

918

607

919, 920

A side 606

B side 611

FIG. 7

607 E

606

913

611

15A898

914

915

FIG. 8

CAUTION

Do not assemble static mixer directly to fluid manifold. Install static mixer after first 50 ft. (15 m) of hose to ensure material is completely mixed. Spraying unmixed material could necessitate rework of part sprayed. See Setup in Xtreme Mix Operation manual.

3.Secure fluid metering manifold 15A898 on the cart/stand with 2 screws (913), washers (914) and nuts (915).

309521J 13