Connecting the gas supply, Electrial connection

HOT PARTS

700 mm

Important: make sure the supply pressure conforms with the values shown in the table entitled “Caracteristics of the burners and nozzles”. When the cooker is installed between cabinets (recessed), the gas connection must be effected by an approved flexible hose with bayonet fitting (BS 669 Current Edition). The gas inlet for the cookers is a threaded G 1/2 gas female fitting.

Connecting the gas supply

To make the connection, a flexible hose should be used corresponding to the current gas regulations which are:

•the hose must never be at any point in its lenght in contact with the “hot” parts of the cooker;

•the hose must never be longer than 1,5 metre;

•the hose must not be subject to any tension or torsional stress and it must not have any excessively narrow curves or bottlenecks;

•the hose must be easy to inspect along its entire length to check its condition;

•the hose must always be in good condition, never attempt

to repair.

Important: the installation must comply with gas safety (installation and use) regulations 1984. In all cases for the above, by low, a qualified, corgi approved engineer must be called for installation.

Electrial connection

Power supply voltage and frequency: 230-240V a.c.50/60 Hz.

Note: the supply cable must be positioned so that it never reaches at any point a temperature 50°C higher than the room temperature. The cable must be routed away from the rear vents. Should you require it, you may use a longer cable, however, you must ensure that the cable supplied with the appliance is replaced by one of the same specifications in accordance with current standards and legislation.

Your appliance is supplied with a 13 amp fused plug that can be plugged into a 13 amp socket for immediate use. Before using the appliance please read the instructions below.

WARNING - THIS APPLIANCE MUST BE EARTHED. THE FOLLOWING OPERATIONS SHOULD BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

Replacing the fuse:

When replacing a faulty fuse, a 13 amp ASTA approved fuse to BS 1362 should always be used, and the fuse cover re- fitted. If the fuse cover is lost, the plug must not be used until a replacement is obtained.

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of the correct colour as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Replacements can be obtained directly from your nearest Service Depot.

Removing the plug:

If your appliance has a non-rewireable moulded plug and you should wish to remove it to add a cable extension or to re-route the mains cable through partitions, units etc., please ensure that either:

•the plug is replaced by a fused 13 amp re-wireable plug

bearing the BSI mark of approval.

or:

•the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS 5733) which is accessible without moving the appliance.

Please note: for appliances with a rating greater than 13

amp (eg: electric hob, double ovens and freestanding electric cookers etc.) the mains cable must be wired into a cooker output point with a rating of 45 amp. In this case the cable is not supplied.

Disposing of the plug:

Ensure that before disposing of the plug itself, you make the pins unusable so that it cannot be accidentally inserted into a socket. Instructions for connecting cable to an alternative plug:

Important: the wires in the mains lead are coloured in accordance with the following code:

Green & Yellow	- Earth
Blue	- Neutral
Brown	- Live

If the colours of the wires in the mains lead do not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

Connect Green & Yellow wire to terminal marked “E” or $ or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked “L” or coloured Red. Connect Blue wire to terminal marked “N” or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse. A 15 amp plug must be protected by a 15 amp fuse, either in the plug or adaptor or at the distribution board. If you are in any doubt about the electrical supply to your machine, consult a qualified electrician before use.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance with the following code:

BLUE		“NEUTRAL” (“N”)
BROWN		“LIVE” (“L”)
GREEN AND YELLOW		“EARTH” (“E”)

	GREEN &
	YELLOW
	BROWN	13 amp fuse
	BROWN
	BLUE	CROSS-BAR
		CORD GRIP

Disposing of the appliance

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.

K 3G21/G, K 3G2/G, K 3G21S/IR specifications

The Indesit K 3G21S/IR, K 3G2/G, and K 3G21/G are versatile and efficient gas cookers designed to meet the culinary needs of modern households. These models stand out for their user-friendly features, reliability, and aesthetic appeal, making them a popular choice among home cooks.

One of the primary features of these cookers is their spacious cooking capacity, which allows users to prepare multiple dishes simultaneously. The models are equipped with four gas burners of varying sizes, offering flexibility for boiling, frying, or simmering. This variety ensures that users can select the appropriate burner for their cooking needs, optimizing heat distribution and cooking times.

Safety is also a significant focus in the design of the Indesit K series. Each model is equipped with a flame failure device that automatically cuts off the gas supply if the flame goes out, ensuring peace of mind while cooking. Furthermore, the enameled surface of the cooker makes for easy cleaning, as spills and residues can be wiped away with minimal effort.

In terms of technology, the Indesit K series incorporates an automatic ignition system, allowing users to ignite the burners effortlessly with a simple push and turn of the control knob. This convenient feature eliminates the need for matches or lighters and enhances the overall safety of the cooking experience.

The ovens featured in these models offer both conventional and fan-assisted cooking functions, allowing users to achieve excellent baking results every time. The fan cooking option promotes an even distribution of heat, which is ideal for baking or roasting, ensuring that dishes are cooked evenly throughout.

Aesthetically, the Indesit K series is designed with a sleek and modern finish that complements any kitchen decor. The combination of stainless steel and other premium materials not only adds to the visual appeal but also ensures durability.

In summary, the Indesit K 3G21S/IR, K 3G2/G, and K 3G21/G are excellent choices for anyone seeking reliable and efficient gas cookers. With a range of modern features, safety technologies, and a stylish design, these models provide a fantastic cooking experience that meets the demands of everyday cooking while ensuring safety and ease of use.