■Before connecting to the SPEAKERS
terminal
A speaker cord is actually a pair of insulated cables running side by side. Cables are colored or shaped differently, perhaps with a stripe, groove or ridges.
Connect the striped (grooved, etc.) cable to the “+” (red) terminals of this unit and your speaker. Connect the plain cable to the
Remove approximately 10 mm (3/8”) of insulation from the end of each speaker cable and then twist the bare wires of the cable together to prevent short circuits.
10 mm (3/8”)
■Connecting to the SPEAKERS terminals
2 
1 | Red: positive (+) |
| |
| Black: negative |
| 3 |
1Loosen the knob.
2Insert the bare end of the speaker wire into the hole on the terminal.
3Tighten the knob to secure the wire.
Connecting the banana plug
The banana plug is a
Banana plug
Connections
Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to “6Ω MIN” as follows BEFORE using this unit.
1Make sure this unit is turned off.
See page 21 for details about turning on or off this unit.
2Press and hold 0TONE CONTROL and then press 1STANDBY/ON to turn on this
unit.
This unit turns on, an the advanced setup menu appears in the front panel display.
3Press APROGRAM l / h repeatedly to select “SP IMP.”.
The following display appears in the front panel display.
SP IMP.- 8 MIN
4Press BSTRAIGHT repeatedly to select “6Ω
MIN”.
The following display appears in the front panel display.
SP IMP.- 6 MIN
5Press 1STANDBY/ON to confirm your selection and set this unit to the standby mode.
Note
The setting you made is reflected next time you turn on this unit.
PREPARATION
English
