Selecting the night listening mode

The night listening modes are designed to improve listenability at lower volumes or at night.

1Press D AMP and then press L NIGHT repeatedly to select “NIGHT:CINEMA” or “NIGHT:MUSIC”.

Choices: NIGHT:CINEMA, NIGHT:MUSIC, OFF

Select “NIGHT:CINEMA” to reduce the dynamic range of film soundtracks and make dialog easier to hear at lower volumes.

Select “NIGHT:MUSIC” to preserve ease-of- listening for all sounds.

Select “OFF” if you do not want to use this feature.

y

When a night listening mode is selected, the NIGHT indicator lights up in the front panel display.

2Press G l / h to adjust the effect level while “NIGHT:CINEMA” or “NIGHT:MUSIC” is displayed in the front panel display.

Choices: MIN, MID, MAX

Select “MIN” for minimum compression.

Select “MID” for standard compression.

Select “MAX” for maximum compression.

y

“NIGHT:CINEMA” and “NIGHT:MUSIC” adjustments are stored independently.

Notes

You cannot use the night listening modes in the following cases:

when the DIRECT STEREO mode (see page 34) is selected.

when the component connected to the MULTI CH INPUT jacks is selected as the input source.

when headphones are connected to the PHONES jack.

when the sound field program is selected while you enjoy music contents in a USB memory device etc.

The night listening modes may vary in effectiveness depending on the input source and surround sound settings you use.

Playback

Displaying signal information

You can display the format, sampling frequency, channel, bit rate and flag data of the current input signal.

1Press D AMP and then press Q MENU on the remote control.

The top “SET MENU” display appears in the OSD.

SET MENU

TOP MENU

. ;AUTO SETUP ;MANUAL SETUP

.A;SIGNAL INFO

[p]/[p]:Up/Down [ENTER]:Enter

2Press G n repeatedly to select “SIGNAL

INFO” and then press G ENTER.

The following information about the input source appears in the OSD.

;SIGNAL INFO

. FORMAT DolbyD SAMPLING 48kHz CHANNEL 3/2/0.1 BITRATE 384kbps

FLAG None [RETURN]:Exit

Display

Description

FORMAT

Signal format.

 

 

 

The number of samples per second taken

SAMPLING

from a continuous signal to make a

 

discrete signal.

 

 

CHANNEL

The number of source channels in the

input signal (front/surround/LFE).

 

 

 

BITRATE

The number of bits passing a given point

per second.

 

 

 

 

Flag data encoded in DTS, Dolby Digital,

FLAG

or PCM signals that cue this unit to

 

automatically switch decoders.

 

 

y

The information indicated by the cursor is also displayed in the front panel display.

3Press Q MENU again to exit from “SET MENU”.

OPERATION

BASIC

 

 

English

35 En

Page 39
Image 39
Yamaha RX-V561 owner manual 35 En, Selecting the night listening mode, Displaying signal information