Troubleshooting
Problem | Cause | Remedy | See | |
page | ||||
|
|
| ||
The sound suddenly | The protection circuitry has been activated | Check that the impedance setting is correct. | 13 | |
goes off. | because of a short circuit, etc. |
|
| |
Check that the speaker wires are not touching each | — | |||
|
| |||
|
| other and then turn this unit back on. | ||
|
|
| ||
|
|
|
| |
| The sleep timer has turned off this unit. | Turn on this unit, and play the source again. | — | |
|
|
|
| |
| The sound is muted. | Press O MUTE or R VOLUME +/– on the remote | 36 | |
|
| control to resume audio output. | ||
|
|
| ||
|
|
|
| |
Sound is heard from | Incorrect cable connections. | Connect the cables properly. If the problem persists, | ||
the speaker on one |
| the cables may be defective. | ||
|
| |||
side only. |
|
|
| |
Incorrect settings in “SP LEVEL”. | Adjust the “SP LEVEL” settings. | 34 | ||
| ||||
|
|
|
| |
Only the center | When playing a monaural source with a | This is not malfunction. |
| |
speaker outputs | CINEMA DSP program, the source signal |
|
| |
substantial sound. | is directed to the center channel, and the |
| — | |
| front and surround speakers output effect |
|
| |
| sounds. |
|
| |
|
|
|
| |
No sound is heard | “CENTER” in “SET MENU” is set to | Set “CENTER” to “SML” or “LRG”. | 48 | |
from the center | “NONE”. |
| ||
|
| |||
speaker. |
|
|
| |
One of the HiFi DSP programs (except for | Try another sound field program. | 37 | ||
| ||||
| 5ch Stereo) has been selected. |
| ||
|
|
| ||
|
|
|
| |
No sound is heard | “SUR. L/R SP” in “SPEAKER SET” is | Set “SUR. L/R SP” to “SML” or “LRG”. | 49 | |
from the surround | set to “NONE”. |
| ||
|
| |||
speakers. |
|
|
| |
This unit is in the “STRAIGHT” mode | Press BSTRAIGHT on the front panel so that | 38 | ||
| ||||
| and a monaural source is being played | “STRAIGHT” disappears from the front panel | ||
| back. | display. |
| |
|
|
|
| |
No sound is heard | “LFE/BASS OUT” in “SPEAKER SET” | Set “LFE/BASS OUT” to “SWFR” or “BOTH”. |
| |
from the subwoofer. | is set to “FRONT” when a Dolby Digital |
| 49 | |
| or DTS signal is being played. |
|
| |
|
|
|
| |
| “LFE/BASS OUT” in “SPEAKER SET” | Set “LFE/BASS OUT” to “SWFR” or “BOTH”. |
| |
| is set to “SWFR” or “FRONT” when a 2- |
| 49 | |
| channel source is being played. |
|
| |
|
|
|
| |
| The source does not contain low- | This is not malfunction. | — | |
| frequency bass signals. |
| ||
|
|
| ||
|
|
|
|
