Optimizing the speaker setting for your listening room
6Press G ENTER to display the setup results in detail.
7Press G l / h repeatedly to toggle between the setup result displays.
Results of the speaker connection and wiring
Results of the speaker distance from the listening position
Results of the speaker size
Results of the speaker output level
y
If you are not satisfied with the results or want to manually adjust each parameter, run “MANUAL SETUP” (see page 46).
Note
The distances displayed in the “DISTANCE” results may be longer than the actual distance depending on the characteristics of your speakers.
8Press G ENTER to return to the “AUTO:RESULT” display.
AUTO:RESULT
NO WARNING RESULT
SP : 3/2/0.1
DIST: 3.2/3.5m
LVL :
. >SET CANCEL [
]/[
]:Up/Down [ENTER]:Enter
9Make sure the pointer is pointing at “SET” and “CANCEL” and then press G l / h to
select “SET” or “CANCEL”.
Choices: SET, CANCEL
•Select “SET” to confirm the “AUTO SETUP” results.
•Select “CANCEL” to cancel the “AUTO SETUP” results.
10Press G ENTER to confirm your selection.
The top “SET MENU” display appears in the OSD.
SET MENU
TOP MENU
. ;AUTO SETUP ;MANUAL SETUP
.A;SIGNAL INFO
[p]/[p]:Up/Down [ENTER]:Enter
11Press Q MENU to exit from “SET MENU”.
12Disconnect the optimizer microphone from this unit.
The optimizer microphone is sensitive to heat. Keep it away from direct sunlight and do not place it on top of this unit.
y
If you change speakers, speaker positions, or the layout of your listening environment, run “AUTO SETUP” again to
recalibrate your system.
