Yamaha RX-V561 Setting remote control codes, 59 En, Remote control code default settings

Setting remote control codes

You can control other components by setting the appropriate remote control codes. For a complete list of available remote control codes, refer to “List of remote control codes” at the end of this manual.

Remote control code default settings

Remote control features

1While pressing and holding one of the input selector buttons (C) on the remote control to

select the input area you want to set up, press AV POWER for more than 3 seconds.

CD MD/CD-R TUNER

Input	Component	Manufacturer	Default
source	category		code
CD	CD	YAMAHA	5013

DVD DTV/CBL DVR

V-AUXUSB

POWER

AV

MD/CD-R	CD-R	YAMAHA	5001
DVD	DVD	YAMAHA	2000
DTV/CBL	–	–	–
TUNER	TUNER	YAMAHA	5007
V-AUX	–	–	–
USB	USB	YAMAHA	5012
DVR	DVR	YAMAHA	2011
	–	–	–

Note

You may not be able to operate your Yamaha component even if a Yamaha remote control code is preset as listed above. In this case, try setting another Yamaha remote control code.

While holding down Press for 3 seconds

2Press the numeric buttons (0 to 9) (W) to enter the four-digit remote control code for the component to be used.

Notes

•If the manufacturer of your component has more than one code, try each of them until you find the correct one.

•If you do not press any buttons within 30 seconds in step 2, the setup process is canceled. If this happens, repeat the setup procedure.

OPERATION ADVANCED

English

59 En