Care and Cleaning
Take care that the rating label edges are not lifted GB during cleaning, and furthermore that the lettering is
not blurred or removed.
Control Panel:
Wipe with a damp cloth and polish with a dry cloth.
Stainless trims
Regularly wipe with a clean, damp cloth and polish with a clean dry cloth.
Grill Door:
Wipe over the grill door decorative outer panel; with a cloth wrung out in warm soapy water, then after wiping with a cloth wrung out in clear water, dry with a soft clean cloth.
Do not use scouring pads or abrasive powder which may scratch the surface.
Ensure that the glass panel (where fitted) is not subjected to any sharp mechanical blows.
Grill:
Remove the grill pan and the wire grid food support, it is best to wash these items immediately after each use to prevent stains from being burnt on when used again. Wipe out the Grill compartment, use a fine steel wool soap pad to remove stubborn stains from the compartment.
Main oven:
1.Glass Door - open the oven door fully.The glass panel may now be cleaned. Stubborn stains can be removed by using a fine steel wool soap pad.Do not use scouring pads, or abrasive powder, which will scratch the glass. Ensure that the glass panel is not subjected to any sharp mechanical blows. For slight soiling the inner glass panel may be cleaned, while still warm. For removing stubborn stains see page 25, cleaning.
2.Remove the rod shelves and meat pan. Use a fine steel wool soap pad to remove stubborn stains from the rod shelves,meat pan and the floor of the oven. Refer to the instructions on page 23 for cleaning the shelf supports. Do not use aerosol cleaners on this oven as they could adversely affect the fan motor unit, and cannot be wiped off the fan blade.
Replacement oven lamp:
WARNING: To avoid electric shocks - please ensure that the electricity supply to the appliance is switched off and the appliance is fully cold, before removing the lamp lens.
Open the oven door and remove the rod shelves. Using a suitable cloth to protect the fingers grip the light glass dome, unscrew
A
Care must be taken that rating label edges are not lifted during cleaning and furthermore that the lettering is not blurred or removed. For details of your nearest Service Centre please see the separate service leaflet. If you have any queries regarding service or spares, our Parts and Service Division will be pleased to advise.
See Key Contacts, back page, for details.
Take particular care not to damage the inner surface of the door inner glass that is coated with a heat reflective layer.Do not use scouring pads, or abrasive powder, which will scratch the glass. Ensure that the glass panel is not subjected to any sharp mechanical blows.
Stubborn stains can be removed by using a fine steel wool pad. For slight soiling the inner glass panel may be cleaned, while still warm, without removing it from the door. After cleaning, rinse and dry with a soft cloth.
CLEANING THE DOORS
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down doors,except take care to support the weight of the inner glass when removing and refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1.Open the door fully and unscrew the two screws securing the glass panel so that the securing brackets can be turned.There is no need to remove the screws completely.
2.Turn the brackets so that 
the glass can be
removed and cleaned at the sink (Fig. 1.)
3.The inside of the outer
door glass can now be 
cleaned while still fitted to
the cooker.
20