Master Bilt BMG/TMG 27, 80, 48, 74, 52 manual Ground Required

Page 5

WARNING LABELS AND SAFETY INSTRUCTIONS

This symbol is the safety-alert symbol. When you see this symbol on your cabinet or in this manual, be alert to the potential for personal injury or damage to your equipment.

Be sure you understand all safety messages and always follow recommended precautions and safe operating practices.

NOTICE TO EMPLOYERS

You must make sure that everyone who installs, uses or services your cabinet is thoroughly familiar with all safety information and procedures.

Important safety information is presented in this section and throughout the manual. The following signal words are used in the warnings and safety messages:

DANGER: Severe injury or death will occur if you ignore the message.

WARNING: Severe injury or death can occur if you ignore the message.

CAUTION: Minor injury or damage to your cabinet can occur if you ignore the message.

NOTICE: This is important installation, operation or service information. If you ignore the message, you may damage your cabinet.

The warning and safety labels shown throughout this manual are placed on your Master-Bilt Products cabinet at the factory. Follow all warning label instructions. If any warning or safety labels become lost or damaged, call your customer service department at (800) 684-8988 for replacements.

 

CAUTION!

 

GROUND REQUIRED

 

FOR SAFE OPERATION

 

This label is located on top of the electrical control

This label is attached to the cabinet power cord

 

label and on the wiring channel.

on models with a power cord.

5

Image 5
Contents LAE Controller Page Table of Contents Store Conditions IntroductionGround Required Installation Instructions PRE-INSTALLATION InstructionsInspection for Shipping Damage General InstructionsElectrical Cabinet should be groundedGrill DoorsManual Defrost MASTER-BILT Electronic Refrigeration ControlHOW to Change the Setpoint Service Instructions Final Check List Temperature Sensors and FAN Motor ReplacementBMG/TMG-27 BMG/TMG-48 BMG/TMG-52 BMG/TMG-74 BMG/TMG-80 MASTER-BILT Part ListOwner Responsibility Sale and DisposalPage