Door Sealing
Check the seal of the doors (See Art00980).
If either door does not seal correctly, excess frost will collect inside the refrigerator. Make sure the doors seal correctly:
-Close each door on a piece of paper that is about the size and thickness of a dollar bill.
-Gently pull the paper.
-You should feel a slight drag between the gasket and the cabinet.
-Do this on all four sides of the door.
-If you do not feel a slight drag on the paper, the door does not seal correctly.
-Have your dealer or an authorized Norcold Service Center correct the seal of the door.
Refrigerator Storage
Before the refrigerator is stored for an extended (seasonal) period of time:
-Defrost and clean the interior of the refrigerator.
-Close the doors with the storage latch.
If the refrigerator is stored for an extended period of time, before start up:
-Make sure there are no obstructions in the vents, the ventilation air pathway, the burner, the orifice, or the flue area.
Refrigerator Maintenance Checklist
Read and understand the following maintenance sections of this manual.
NOTE: Norcold is not responsible for installation, adjust- ment, alteration, service, or maintenance performed by anyone other than a qualified RV dealer or a Norcold authorized service center.
Have a qualified RV dealer or a Norcold authorized service center do these annual safety and maintenance checks:
-Examine the gas supply lines for leaks.
-Replace or repair if needed.
-Make sure the propane gas pressure is 11 inches water column.
-Adjust if needed.
-Make sure the combustion seal is complete and intact.
-Replace or repair it if needed.
-Make sure the burner and the burner orifice are clean.
-Clean if needed.
-Make sure the electrode is clean and the spark gap is 1/8 - 3/16 inch.
-Adjust if needed.
-Make sure the AC voltage is 108
Ice Maker Storage (Optional)
To prepare the ice maker for seasonal storage:
1.Close the vehicle water supply valve to the ice maker.
2.Push the ice maker arm up until it locks into the OFF position.
3.Remove the garden hose adapter from the water solenoid valve.
4.Remove the ice maker water line from the water solenoid valve
-Do not unwrap the water line heater wires from around the water solenoid valve.
5.Drain all of the water from both the water supply line and the ice maker water line.
6.Put the end of the water supply line, the end of the ice maker water line, and the water solenoid valve each into a clean plastic bag.
7.Use tape to close each plastic bag around the water lines and the water solenoid valve.
To use the ice maker after seasonal storage:
!CAUTION: Do not operate the ice maker when the ambient air temperature is 0° F. or lower. Damage to the water solenoid valve and the water supply line can occur.
Owner’s Manual 11