1.Remove the tape and plastic bags from the end of the water supply line, the end of the ice maker water line, and the water solenoid valve.
2.Connect the ice maker water line to the water solenoid valve.
3.Connect the garden hose adapter to the water solenoid valve.
4.Push the ice maker arm down into the ON position.
5.Open the vehicle water supply valve to the ice maker.
NOTE: You should discard and not use the first two batches of ice cubes. It will take about three cycles for the ice maker to make fully formed and clean ice cubes.
Refrigerator Maintenance
Gas flame appearance:
While in LP GAS operation, examine the appearance of the gas flame:
-Push the TEMP SET button until the number “9” appears in the center display.
-Open the lower intake vent.
!CAUTION: The burner box cover can be hot. Wear gloves to avoid burns.
-Look at the gas flame [75] (See Art00955).
-The flame should be:
-a darker blue color on the inside of the flame and a lighter blue color on the outside of the flame.
-a constant shape without flickering.
-Contact your dealer or Norcold authorized service center if the flame is:
-yellow
-flickering or changing shape.
-Make sure the flame does not touch the inside of the flue tube [76].
-If the flame touches the inside of the flue tube, contact your dealer or Norcold authorized service center.
-Close the burner box door.
Remove and clean the burner orifice:
Your dealer or Norcold authorized service center must do this procedure.
Remove and clean the burner orifice (See Art00956):
-Close the valve at the propane gas tank(s).
-Push the ON / OFF button to shut down the refrigerator.
-Open the lower intake vent.
!CAUTION: The burner box cover can be hot. Wear gloves to avoid burns.
-Remove the burner box cover by removing the screw(s).
!WARNING: To avoid possible propane gas leaks, always use two wrenches to loosen and tighten the gas supply line connections.
-Remove the flare nut from the orifice assembly [77] (See Art00956).
-Remove the orifice assembly from the burner [78].
!WARNING: Do not try to remove the orifice [79] from the orifice adapter [80] when cleaning. Removal will damage the orifice and seal of the orifice and can cause a propane gas leak. Leaking propane gas can ignite or explode which can result in dangerous personal injury or death. Do not clean the orifice with a pin or other objects.
-Clean the orifice assembly with air pressure and alcohol only.
-Using a wrench, assemble the orifice assembly to the burner.
-Assemble the flare nut to the orifice assembly.
-Examine all of the connections for gas leaks.
-Assemble the burner box cover.
Owner’s Manual 12