PROBLEMS WITH YOUR WINE CELLAR
You can easily solve many common wine cellar problems, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before contacting Vinotemp at info@vinotemp.com.
TROUBLESHOOTING GUIDE
| PROBLEM | POSSIBLE CAUSE | |
|
|
|
|
| Wine cellar does | • | Not plugged in |
| not operate | • | Using wrong voltage |
|
| • The circuit breaker tripped or a fuse is blown | |
| Wine cellar is not | • Check the temperature control setting as | |
| cold enough |
| external environment may require a higher |
|
|
| setting |
|
| • The door is opened too often | |
|
| • The door is not closed completely | |
|
| • The door seal does not seal properly | |
|
| • The wine cellar does not have the correct | |
|
|
| clearances to operate efficiently, safely and |
|
|
| correctly |
| Light does not | • | Call the service center |
| work |
|
|
| Vibrations | • Check to assure that the wine cellar is level | |
|
|
| |
| Wine cellar seems | • The wine cellar is not level | |
| to make too much | • Check the fans inside and at the back of unit | |
| noise |
|
|
| Door will not close | • The wine cellar is not level | |
| properly | • The doors were not properly installed | |
|
| • The seal is weak | |
|
| • The shelves are out of position | |
|
|
| |
| Temperature LED | • Main control board does not work | |
| display is blank | • The Power Control Board is not functioning | |
|
| • There is some problem with the plug (no | |
|
|
| power supply) |
| Temperature LED | • Display has suffered too much wear and tear | |
| display error | • Temperature sensor has been cut off | |
| Buttons are not | • Temperature controller panel is damaged | |
| functional |
|
|
10 | W W W . V I N O T E M P . C O M | ||