TROUBLESHOOTING
BURNERS WILL NOT LIGHT ON GAS OVEN
1.Check that door is shut.
2.Press the OFF button to turn the oven off and wait 5 minutes.
3.Make sure the gas shutoff valve is in the ON position.
4.Press the ON button to turn the oven back on.
If the above suggestions do not remedy the problem, contact a Hobart Bakery Systems service office.
OWNER PREVENTIVE MAINTENANCE PROCEDURE
INTRODUCTION
This customer preventive maintenance (PM) section includes procedures to inspect for proper operation and cleaning of components. Owner Preventive Maintenance Procedures are written for gas ovens. They can also be used for electric ovens by omitting the steps that refer to components found only on gas ovens. Customer PMs should be conducted
NOTE: This PM procedure does not discuss repair or replacement of components. Upon completion of the PM procedure you will need to contact a qualified service for any needed repairs.
Tools Used For Inspection Procedure
•Standard set of hand tools
•Vacuum cleaner - shop vac
PREVENTIVE MAINTENANCE PROCEDURE
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES.
WARNING: SHUT OFF THE GAS BEFORE SERVICING THE UNIT.
WARNING: CERTAIN PROCEDURES IN THIS SECTION REQUIRE ELECTRICAL TEST OR MEASUREMENTS WHILE POWER IS APPLIED TO THE MACHINE. EXERCISE EXTREME CAUTION AT ALL TIMES. IF TEST POINTS ARE NOT EASILY ACCESSIBLE, DISCONNECT POWER AND FOLLOW LOCKOUT / TAGOUT PROCEDURES, ATTACH TEST EQUIPMENT AND REAPPLY POWER TO TEST.
Inspect Oven Lamps
1.Lamps should be on when oven is powered.
2.If not, replace lamps (Fig. 1).
A.Remove lens cover by turning out of lamp housing.
B.Remove oven lamp by turning lamp out of lamp socket.
3.Reverse the procedure to install new lamps.
Fig. 1
– 25 –
